Location
Salt Lake City, UT
About
About Me:
Mechanical Engineering Student
Please tell us a bit about your UAV interest
I want to integrate a chemical sensors into a drone so that it can do the reconnaissance.
Hometown:
Salt Lake City
Activity Feed
Does anyone know why these ESCs are not working with my pixhawk? I put my pixhawk into calibration mode with the esc hooked up and wait for the beeps representing my battery cell count, but I never hear anything. I then moved my throttle to the…
"Yes I have check my baudrate on my Intel edison multiple times now, I set it in my .bashrc with the line stty -F /dev/ttyMFD1 57600.
Yes the intel edison J19 pin 3 is connected on TELEM2 ground. I will send pictures of my setup so you can have a…"
Yes the intel edison J19 pin 3 is connected on TELEM2 ground. I will send pictures of my setup so you can have a…"
"@Glenn
Thanks for the response. So I realized the intel edison is on a 1.8V logic but i have seen other people to get the intel edison and pixhawk to successfully talk to each other so i know it's possible without a level shifter. Doesn't my…"
Thanks for the response. So I realized the intel edison is on a 1.8V logic but i have seen other people to get the intel edison and pixhawk to successfully talk to each other so i know it's possible without a level shifter. Doesn't my…"
"I am new to the community and so if this is the wrong place to post this please forward me to the correct forum.
I am trying to get a intel edison to be a companion computer for the pixhawk (apm firmware). I am using J18 pin 13, J19 pin 8 and 3…"
I am trying to get a intel edison to be a companion computer for the pixhawk (apm firmware). I am using J18 pin 13, J19 pin 8 and 3…"
