Gender
Male
About
Location
Eureka, Ca
About Me:
Here
Please tell us a bit about your UAV interest
Ready
Activity Feed
"jason -
2.0.34 is simply AMAZING! I have not felt comfortable with my quad ever since removing the Gaui gyro, until tonight. Yaw is rock solid, job well done. I had a couple wobbly moments but the default PID feels pretty good, minor tuning for…"
2.0.34 is simply AMAZING! I have not felt comfortable with my quad ever since removing the Gaui gyro, until tonight. Yaw is rock solid, job well done. I had a couple wobbly moments but the default PID feels pretty good, minor tuning for…"
"Telemetry port is used, all sensors come from ACM except motor battery voltage which is pulled from balance port direct to remzibi.
Altitude is not playing nice, compass should be used (if available) over gps course, and still need to get current…"
Altitude is not playing nice, compass should be used (if available) over gps course, and still need to get current…"
"Updated to 2.0.31b modified with Remzibi OSD code.
Had massive yaw swings that were not present before.
No wind, nice conditions, little dark.
Not seeing alt in the OSD for some reason, and alt hold is not holding very well, shoots up up and away.…"
Had massive yaw swings that were not present before.
No wind, nice conditions, little dark.
Not seeing alt in the OSD for some reason, and alt hold is not holding very well, shoots up up and away.…"
"I also experienced the alt hold issue in .31, also had some crazy yaw stuff going on, would have massive corrections almost crashing without warning. First flight there was no logs, used APM Planner and deleted (no) logs but after that clear I was…"
Gaui 330X-S / ArduCopter 2 / Remzibi OSD from Kevin M. on Vimeo. ArduCopter 2.0.30b modified with Remzibi OSD code.Needs PID tuning and less windy conditions.Video is on 2.4gHz, in residential neighborhoods it looks terrible! At the field it's much…
"Had a similar problem with my setup, however it was back and to the right. I ran level several times, watched for drift with sensors, couldn't figure it out. I brushed the ESC on the back right side and it was quite warm where all the rest were cool…"
"Had this happen a few times when loading code. Re-run radio setup and don't push right really hard on the stick, then see if it will arm. I believe full right stick in calibration is more stick than what I was giving it to arm."
"APM_Config is missing some good info available in AdvancedConfig at http://code.google.com/p/ardupilot-mega/wiki/AdvancedConfig . Magnetometer test is missing enter for return. Also had some kind of funky problem where I couldn't get CLI with…"
