"I connect the TM1000 voltage connector to my flight pack directly. I don't think there is any battery pack voltage at the APM."

"What happens when you disconnect the camera? Do you see the overlay then?"

"Sounds like your pan servo drew more than 0.5A and blew the fuse on the APM."

"I have been trying out various flight modes on my 3DR Hexa, 880kv motors, 3S battery, APM 2.5 w2.9.1 firmware and more or less default tuning. It flies very well in Stabilize and Alt-Hold is rock steady with very little climb or descent while…"

"I am glad I am not the only person with this issue :-) I've tried NTSC and PAL to see if that makes a difference and it doesn't. I am going to try a different video source to see if that changes anything - but I need to make up another video cable…"

"Sounds like the drone needs to be armed. If you cannot arm the motors you may need to recalibrate your radio. Also, make sure your flight mode switch is in stabilise."

"There were actually quite a few parts missing from my 3DR  Hexa-B but they were generally just some of the small hardware bits such as one of the 35mm bolts, quite a few of the M3 nuts and the four rubber washers. Nothing that could not be solved by…"

"I can build and upload 2.9-rc5 no problem. However, when I then try to load the released 2.9 via mission planner, the radio calibration does not work in that it will not refresh values from the transmitter. Going back to the rc5 build works fine…"