Be careful to buy 3D printers in crowdfunding campaigns !
One of the most commons errors that startup companies do is to sell at too much low prices their printers in the crowdfunding campaign .
Then they will do not have enough money to build and shi
Read more…Pixhawk last revision with 3.3.3 firmware.
It is not the first time it happens, but previously I suspect bad compass , Gps gliches, solar storms .
Today I check everything twice and all was going well.
The symptoms that something is going bad soon is t
Read more…Hi all,
I have made several missions using the Do-Set-Cam-Trigg-Dist command and a distance of 6 meters.
But the number of shooted photos considering the distance the copter flew from first to last waypoint is about the half .
The camera a Sony A7R as a
Read more…I have read here (http://tuffwing.com/support/geotag_gopro_images_with_pixhawk_log.html) that to be shure that Cam events , like Do-Set-Cam-Trigg-Dist, will be recorded on the flyght log , the value of LOG_BITMASK 655358 must be set .
The problem is
Read more…After 80 flights with my hexa and Pixhawk in the last two years without any problem I destroy it in a few minutes.
Actually I'm using last firmware version and did six flights without any problem, the last one in the morning, in the afternoon , after
Italy already has very strict and severe rules.
What happened during Madonna di Campiglio, Italy, Men's Slalom
(low temperatures and dead batteries I suppose ? )
Will be very bad for drones ...
http://media2.corriere.it/corriere/content/2015/12/22/Sport/
Read more…I'm using version 3.13 with an Hexa ,
Even if I change the value of circle_radius from 20 to 30 the copter circle perfectly but only with a radius around 10 meters .
Also the circle_rate with values 10 and 50 related to CH6 and a potentiometer on th
Read more…I have recently bought a APM 2.6 , I use a custom build brushless gimball for Sony cx730 and only pins A10 and A11 have a PWM output while I need another one for the zoom function of the Sony.
I have tried to set PAN in Gimball menu, select both A9 o
Read more…I have bought several Esc that were supposed to be opto isolated (ZTW 20A, RC Timer 30A) , all without a Bec.
But when I checked with a multimeter the ground supply and the ground signal that goes to the receiver/APM, were in common.
So how can these
Read more…