"Hi just installed v3.2 rc2 all went well but when i connect to the terminal so a can do a erase and clear
calibrating barometer appears and then a whole bunch of code keeps on going. How do i stop this so a can gain access the the commands to clear…"
"No one can help?
I just cant get this to work.
I am using the default v2 firmware of turnigy 9x and in non cppm mode everything works fine with all servo wires connected but when i use only one servo wire for cppm mode channel 5 and 6 get swapped on…"
"Thanks for the reply.
Yes i know opentx will resolve my problem, but to do that i would have to update my turnigy 9x firmware(i have the v2 firmware). And i can only do that by buying extra hardware which i don't think it is worth it. Might as well…"
"Thanks but that doesnt help my problem.
The link you gave me is to update to 27ms and to allow the usage of ppm-sum(CPPM) and i did that.
When i had normal ppm with all the servo wires connected. channel 5 worked fine and i could use it with a mix…"
"Hi i successfully upgraded the firmware of my d8r-ii plus to the xp 27ms.
plugged the servo wire from channel 1 to port 1 of the apm.
Bridged the signal from channel 3 and 4 from d8r-ii ,plug and bridged the signal from 2 and 3 on the apm.
"This is how i got my setup. So far no magic smoke.
I use the internal battery of my gopro.
Do you guys think i can continue to use this or am i looking for trouble?
If i decide to power my gopro from my lipo can i just pass a wire from 5v out of the…"
"This is something i would also like to get. Althold flying ability but loiter gps lock when the quad it still.
You can make loiter fly fast but it had this rocking(boat) feeling at least i get it.
This is what i asked on another thread:
"Hi, got 3.1rc7 done autotune and things are great!
I got all flight modes working fine and i'm happy with apm 2.6 performance.
I like althold mode to fly around but would like the gps lock feeling that loiter gives you when you stop. althold tends…"