Gender
Male
About
Location
Colfax, IN
About Me:
good at everything. Master Electrician. certified structural welder.
Please tell us a bit about your UAV interest
I want to build a MQ-9 Reaper that I have already purchased. I need it to loiter for a long period of time with the max range of at least 15mi. I have just bought the audrpilot mega and looking foward to writing some code for it. I liked it better than the other autopilots because it is open source. good stuff cant wait to recieve in it the mail.
Hometown:
Massillon, Ohio
Activity Feed
3DR works great with mission planner MAV 1.0 and with Qgroundcontrol but I can not get to connect to Happykillmore CGS. Is it a different baud rate? I have went over all the wiki and can not find any answers. Please any help would be great...Cheers
"Hey Dexter,
Please read all instructions before asking any questions. All the answers that you seek are waiting for you on the set up page in the instruction section or in the discussion section of this site. Thankyou."
Please read all instructions before asking any questions. All the answers that you seek are waiting for you on the set up page in the instruction section or in the discussion section of this site. Thankyou."
"I guess I just want someone to say " yes you f!*ked up! " so I can justify ordering another board. I would order an APM2 but I got to much money wrapped up in my oil pan. mag, pitot breakout and xbee breakout. I know the APM2 has these features…"
"The APM mission planner even shows that it is giving an output to the offending channels but I am getting nothing on the output signal pin for said channels. Even in MUX pass through mode (manual)."
"I did as you instructed and still no joy. I was hooking up a light controller from Dimension Engineering and accidently gave the APM two power sources. That's when I noticed the problem. The APM was working properly on all channels before I did…"
Hello, I am having a problem with my APM 1. Channel 1 and 4 OUT are not working. I have read everything and did all my homework. Everything else is working Mag,accel,gyro,gps,CH3,CH2......ect. Could I have burned my board by accidently plugging…
