Gender
Male
About
Please tell us a bit about your UAV interest
Just tarted with multirotors
Hometown:
Singapore
Activity Feed
"how your passive thrust vectoring works ??? "
"G=2.4g P=PCM"
"A=Airplane H=Heli"
"10CAG only 2.4g 10CAP 2.4g & FM module"
"Futaba 10CAP"
"I did follow every steps ... but still can't get "
"anybody managed to get all 6 modes on 10C ???"
"So how can I upload the file ???"
"my 10C range too narrow .... I followed the instructions above only managed to set 2 mode ...."
"The tail angle are 40 degrees ..."
"My friend's use KKplus controller board everything works nicely ......http://youtu.be/wdTAOqWnfh4"
The Hunter-Vtail 500mm frame, available from QcRc.ca, is constructed in black G10 and uses aluminum standoffs. It uses an unusual arrangement of motors, with which "the yaw autority is not only managed by the torque of the motors, back motor are…
"Hi Mathew, I'm using the frame above .... only 4 motors"
"Hi Mathew, any idea how should I set mixing for Vtail ???"
