About

Gender

Male


Location

Veneto


Please tell us a bit about your UAV interest

I am assembling my own Arducopter.


Activity Feed

Maximusboscus replied to Rainer's discussion No dataflash log
"Hi Rainer,

Be careful with the Chip Erase function. I found this on the datasheet:

ERRATA
29.1 Chip Erase
29.1.1 Issue
In a certain percentage of units, the Chip Erase feature may not function correctly and may
adversely affect device operation.…"
Oct 31, 2013
Maximusboscus posted a discussion
Hi guys, it's me again :)After braking one of my motors I decided to buy new ones but I don't know what motor to choose:I've seen this…
Jul 9, 2013
Maximusboscus replied to Maximusboscus's discussion Unable to erase DataFlash
"Hello, nobody?

FYI the log in the Dataflash does not change after arming disarming sequences.

Today I'm going to try some flights with a Laptop as a telemetry gound station.

Cheers."
Jul 6, 2013
Maximusboscus posted a discussion
Hi Guys,Today I tried my first flight after a long day of calibrations, was a little scary as I wrapped the receiver antenna (40 MHz) around the frame and it went crazy until i set it free in vertical.The rest was OK for the first flight EXCEPT…
Jul 2, 2013
Maximusboscus posted a discussion
Hello everybody again,I hope the questions I will ask today is not a silly question.I would like to update the firmware of the 3DR Radio and also configure my uBlox NEO.Normally I would need a FTDI cable but I don't have it, so (as the…
Jun 24, 2013
Maximusboscus posted a discussion
Hello everybody,I've been reading a bit the datasheets of both Atmega 2560 & Atmega32U2, but I have a question:If I try to program these two chips by entering in High voltage programming (Serial/Parallel, this means applying 12 Volts to RST), could…
Jun 5, 2013