About

Gender

Male


Location

Vero Beach, FL


About Me:

Sr Program Manager, Piper Aircraft, Inc


Please tell us a bit about your UAV interest

Built quad rotor-Flame Wheel frame, Arducopter APM 2.5 board, DJI motors/ESCs


Hometown:

Vero Beach, FL


Activity Feed

Mitchell Cannon replied to Mr. Santos's discussion DJI F450 Quad, pre assembly Q, confusion about BEC.
"I have a similar setup. I use the 10" props.
Do you have the power module connector option that is available? if so, one lead (thick wires) does to your DJI PDB and the other lead (thick wires) goes to your battery. The small connector connects to…"
Feb 3, 2013
Mitchell Cannon replied to Vindolin's discussion "No dataflash card inserted" notice on APM 2.5
"check the data flash chip on the APM 2.5 board to see if the legs are soldered in place or broken or improperly seated. "
Jan 27, 2013
Mitchell Cannon replied to Peter Chaffe's discussion No dataFlash inserted (new problem)
"check the security of the solder joints of the data flash chip...have you had a crash to cause the data flash chip legs to break free or loose contact with the circuit lines?? or perhaps the chip was not seated when it was assembled??"
Jan 27, 2013