Gender
Male
About
Location
beirut
About Me:
i like anything that flies, but recently i fell in love with multi rotor copters
Please tell us a bit about your UAV interest
im interested in all kinds of UAVs. i've already built more than one UAV planes and now working on multi-rotor UAV's
Hometown:
Lebanon
Activity Feed
"85 knots ? bahahahahahahahhahahahhahahahhahahahahahahahhahahahahahahahahhahaha"
"Question : even if the OCTO looses an engine during flight it should not flip in case i'm flying in stabilize mode right? at least that's what i know !!!! correct me if im wrong"
hi All,i've built my OCTO from scratch. all ESC's are soldered, no bullet connectors.it has been flying great and is tuned in a very good way. i was enjoying it so muchuntil one time it decided to "Flip" just after takeoff, i didn't change any…
"i have the same problem :( and it is very bad. my ESC connections are all soldered and everything is setup right.
note that my OCTO is flying very very good. i had on it more than 170 minutes of flight time, until it decided to snap the first time…"
note that my OCTO is flying very very good. i had on it more than 170 minutes of flight time, until it decided to snap the first time…"
"Hey guys,
here is my build :) hope you like it.
frame: Custom design and scratch built
controller/autopilot: ardumega with acelerometers and sonar
motors: https://store.diydrones.com/Motor_AC2830_358_880Kv_p/ac-0004-05.htm
esc:…"
here is my build :) hope you like it.
frame: Custom design and scratch built
controller/autopilot: ardumega with acelerometers and sonar
motors: https://store.diydrones.com/Motor_AC2830_358_880Kv_p/ac-0004-05.htm
esc:…"
hello folks, i have designed my own OCTO copter (1meter in diameter) + 3 axis camera gimbal from scratch + hard case for the Ardumega and receiver. and would like to share with you what i came up with before i start i would like to note that the…
