"It will be nice so we can add external gyro to the pixhawk"

"Thank you Gerard :)"

"I understand, thanks.
Because i already have sonar and of course i want to use it.
The copter is big and expensive, and i don't want to test beta versions on it.
So I will wait. :/

Have a good day."

"Maybe is normal in stabilize mode to be so aggressive."

"Hi,
This is only if the channel is reverse. :)
Maybe there is some misunderstanding:
- when it has to be pitch it act like roll. This was the problem.
And yesterday I made it, it is easy to change them from "Advance list parameters". You can assign…"

"Can I get telemetry from UART port?
Or for what is use UART on Pixhawk?
If we can use it, we can try this: http://pixhawk.org/peripherals/telemetry/hott"

"Hi,
I am writing because I couldn't find them.

There is a section in the manual:

-Joystick setting:
Detail program description - Joystick setting.
And I am not sure, after I read the manual can I use it for reverse the channels?
-Another option…"

"Hi again,
now I have problem with the channels:
The RC is in airplane mode, and stick mode 1.
The controls are:
- the left side of the RC are the throttle and yall;
- the right side are the roll and pitch.

The problem are the roll and pitch - THE…"

"Thank you,
Strange, I do only the wizard for all the calibrations and then I calibrate the esc. I didn't go to this pids section, because I didn't understand it.
I will make some platform for tests :).
what is the best way to change them, like 0.1…"

"Thank you,
All is good now, but I have problems with config of PID..maybe.
new discussion"

"Thanks,
Next time i will put them under the frame.
But after we set the gimbal with dslr camera under the frame, can we put the batteries at the same place?

We are with default PID.
How to change or with what steps to change PID safely?"

"Hi , thank you.

I have GPS/Compass, calibrated pointing at the same way.
I opened discussion here"

"Thank you for your reply,
Is this the best way, or you can recommend a better"