Gender
Male
About
Location
Odessa, TX
About Me:
Hobbyking q450 frame APM 2.5 Arducopter 3.0.1 FW APM power module 4500 Mah Zippy Compact Lipo Q-brain 25 amp esc tuurnigy multistar 2213 -935 kv motors 10x4.5 props GoPro hero 3 Black Turnigy 9x RX 3dr telemetry radio 4 - 5" led strips tiny 2$ voltage/cell monitor 2 status led's ublox neo 6 GPS
Please tell us a bit about your UAV interest
Multirotor
Hometown:
Odessa tx
Activity Feed
Link! Looks interesting and the price is right! looks like a great option to get into the UAS hobby on the cheap!!Get in the action with the Quanum Nova, the Ready to Fly GPS drone that ticks all the right boxes. Don't let the low price…
"Great exposure for Hobbyking!!"
"have you ever tried thick lexan its nearly indestructible where as acrylic will crack its also very paintable with rc car paint !"
"to no avail....it must be the opto esc's"
"sweet I will try this! Thanks!"
"I really need help with this guys !!"
"Thanks for all of your replies! I would have to completely disassemble my quad copter to install the q-brain in my tri copter , I just can't figure out where the throttle is going once the apm has control of the esc. I get a solid and smooth…"
"stabilize mode , I had this apm in a quad copter before and I was also using a q-grain 4 in 1 esc I didn't experience any problems climbing out with the quad same motors and props."
I have a tricopter setup and after the maiden flight I noticed it doesn't seem to climb out very well. I know I'm not overweight or underpowered , when I calibrate the ESC's and after calibration before restarting the APM hold the copter in my hand…
"does anyone know what I need to tweak to smooth out a quick descent? I'm not very good at tuning and also what do I adjust and where do I adjust to tame down acro mode just a bit to make it a little softer control ?"
"WELL I FINALLY GOT IT FIGURED OUT AND IM AN IDIOT !!!!! LOL I forgot to re calibrate my esc's after swapping the FC!!"
"Ok , I'll try this after work today and post my results !! Thank you very much !"
"OK, so I got that issue fixed by installing my apm 2.5 in the tri-copter since my apm has a case, it now will hold altitude, but now I have a new issue ...... when I take off it wants to pitch fore-ward and the more throttle I give it the more…"
Ok I have built a Tricopter based on RCexplorer's design , I'm running an AIO proV2, with 3.1.1 firmware , I have everything tuned in the way I want it flies wonderfully but I cannot seem to get althold to work, when I flip the switch it somewhat…
