Gender
Male
About
Location
Gainesville, FL
About Me:
Operations Manager at Micro Aerial Projects L.L.C. and passionate about the use of UAVs (especially VTOLs) for aerial mapping, photogrammetry, industrial inspections and HD Aerial Video.
Please tell us a bit about your UAV interest
Special interest in the use of VTOL UAVs for high resolution, low altitude aerial mapping.
Hometown:
Gainesville
Activity Feed
"Gary Scott, if you'd like to purchase a genuine Pixhawk, check out MROBOTICS (Jordi Munoz's company - He was the co-founder of 3DR) @ https://store.mrobotics.io/
If you really want a quality tested product and want to purchase from a company that…"
If you really want a quality tested product and want to purchase from a company that…"
Hi All, We've greatly benefitted from the Open-Source community, especially with APM/Pixhawk and Mission Planner. Part of keeping this community together and advancing is to share our experiences and solutions. To be honest, I haven't had much time…
"Yes, I have managed to do this but I believe I accomplished this with an R7008SB receiver in mode D. I dont have the unit anymore but I had to upgrade to firmware 3.2 from 3.1.5 for it to work. What firmware are you on? "
"It is the V-map System. A geodetic grade dual frequency L1/L2 GPS receiver operating at 20Hz for capturing the precise position of the camera at the moment of exposure. It is a post processing based solution but can be configured for RTK. "
"Just FYI, the Autotune worked!"
Hi Developers and my fellow users,I would like to share with you my great joy and amazement with the success of an autotune I performed on my SteadiDrone QU4D X. The platform uses 100kv motors and had an all up weight of over 9kg. I was very…
"Hi Developers and my fellow users,
I would like to share with you my great joy and amazement with the success of an autotune I performed on my SteadiDrone QU4D X. The platform uses 100kv motors and had an all up weight of over 9kg. I was very…"
I would like to share with you my great joy and amazement with the success of an autotune I performed on my SteadiDrone QU4D X. The platform uses 100kv motors and had an all up weight of over 9kg. I was very…"
"Hi Brad,
I just completed an auto-tune with my quadcopter which uses 100KV motors, 28Inch Props and had an all up weight of over 8kg. Hover thrust was approximately 65%. The Autotune was done in calm wind conditions and was a complete success. I am…"
I just completed an auto-tune with my quadcopter which uses 100KV motors, 28Inch Props and had an all up weight of over 8kg. Hover thrust was approximately 65%. The Autotune was done in calm wind conditions and was a complete success. I am…"
"Incase it is of interest, I have tied this unit down to the ground so that it cannot take off and have run it with slow and fast throttle variations in the full throttle range and have had no sync issues. Obviously, since it is tied down, it is…"
"Hi Scott! If you find anything out, please let me know! I too am trying to find out this information before I put my 20lbs system with 100kv motors and 28 inch props through autotune..."
Perhaps one of the developers could chime in here. I have a question as to whether AutoTune will work well with a platform that weighs almost 20lbs, uses 100kv motors and swings 28inch props. I have not seen any documentation on performing an…
"My apologies everyone for letting this post go so long without notifying you that the problem was discovered and solved! The issue was the ESC choice. For some or other odd reason, these Castle Creation Phoenix Lite 50amp escs caused erratic…"
"Correct, Idaho State University."
"SteadiDrone H6X with APM2.6 has received a COA"
"Hi Keeyen, Sorry however we have not received an enquiry from you. Would you mind sending it again?"
