Paul Har's Posts

Paul Har's Posts (4)

Sort by

Inputting LAT LONG /manually

Posted by Paul Har on June 24, 2009 at 2:46pm

I failed to get the waypoint utility to read and write to the board, and read the comments on the blog.So I want to put them in manually, but the manual says to put them where it says "wp-lat wp-long I cant find these in the code. I am running 2.2.3

GPS Setting to /binary

Posted by Paul Har on June 21, 2009 at 11:04am

I have loaded 2.2 onto the Ardupilot and put the jumper on to set the gps to binary and home position.The blue led blinks fast but never gets a lock, it used to work before I/ tried to set it to binaryPaul

Ground station and config utility

Posted by Paul Har on June 21, 2009 at 3:59am

When I try to run the config utility it comes up with "the application failed to inialize properly(0xc0000135)"Also the ground station wont run as this comes up withThe VI is not executable. the full development version of LabView is required to fix errorsI have downloaded and installed the two items Chris mentioned in the manualAny ideas?Paul

audrino interfaced with xsens?

Posted by Paul Har on May 10, 2009 at 9:20am

Does anyone know if it is possible to interface the xsens mti with the audrino board, can it be donePaul

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

Note: this page contains paid content.