About

Gender

Male


About Me:

Licensed operator in the UK, Love anything tech.


Please tell us a bit about your UAV interest

I have 5 various drones quads and hexa and 6 planes, 1 plane has UAV and 4 drones have various UAV, 1x Naza M 1x 2.5 APM 1x 2.6 APM 1x Multiwii 2.1 for quads and hexa. 1 plane has cyclone UAV on it. APM's working real well, And great value for money. Naza m is still in the box


Hometown:

Barry


Activity Feed

Paul Okelly posted discussions
Jun 13, 2015
Paul Okelly posted a discussion
HiI have updated my firmware from 2.14 to 3.21 with APM planner and since I have done this every time I power up the amp runs through its checks, when finished the bottom left motor starts spinning quite fast. I have a 3DR Y6 B 3DR Compass and…
May 20, 2015
Paul Okelly commented on Paul's blog post DJI INSPIRE 1 in Action
"Wow, I can't believe how the regulations are in the USA, you guys can just pull over on the side of a busy road and take off, theres no way you can do that in the UK, for good reason too. Imagine a failure and the UAV and it went in the path of a…"
Nov 14, 2014
Paul Okelly replied to Paul Okelly's discussion Overheating ESC
"Thanks Emin"
Mar 16, 2014
Paul Okelly replied to Paul Okelly's discussion Overheating ESC
"Thanks for the info, I didn't know it was possible to run 4c on the HL motors because the spec says 6c, my 40amp esc should be ok with these do you think?
thanks"
Mar 6, 2014
Paul Okelly replied to Paul Okelly's discussion Overheating ESC
"Thanks Guys
I have 6 HL W51 34 350kv motors with sec's but they only take 6cell batteries and I have 3c + 4c but limited money. 
Im trying to way up my best, but cost effective solution until I get some more cash, I just obtained my BNUC-s UAS…"
Mar 5, 2014
Paul Okelly replied to Paul Okelly's discussion Overheating ESC
Mar 4, 2014
Paul Okelly replied to Paul Okelly's discussion Overheating ESC
"Thanks Thomas, some real good info for me,, I will look at getting some better sec's, I have a 4c battery I can try, here is a spec of the motor if it helps, in case theres anything else you think I may have an issue will.
No problem if you haven't…"
Mar 4, 2014
Paul Okelly posted a discussion
Hilooking for some help on an issue I have on a new build copter, it  is a Hex 800 with Pixhawk Autopilot.I have Mystery 5010 750kv motors 15 inch tarot blades, with Red Brick 30a ESC, pretty straight forward setup, 5000 30-45c 3cell lipo,all went…
Mar 4, 2014
Paul Okelly replied to Paul Okelly's discussion Gimbal Issue with BGC 3.1 Newb
"Hi Tom
I have 11..1 v lipo straight into the board, gives the motor enough power and is also fine for all components. Hope this helps"
Feb 9, 2014
Paul Okelly posted a discussion
Hifirstly, hello to everyoneI have a BGC Gimbal 3.1 controller from ebay, I have downloaded the software and it is connecting to the controller fine, I have calibrated the gimbal and all looks goodthe problem I am having is when my Y6 rotates left…
Jan 19, 2014