I am setting up a plane I have been flying in manual mode.
My question is, how do I do the transmitter calibration ? The docs says to trim the center points before calibration. But what about end-points ?
Should I calibrate with the same settings used
Read more…I really do not see any reason why I should have the MinimOSD on the plane/copter, if I use 433MHz telemetry radios.
Can't I just connect the 5V, GND, RX to the ground based 3DR Radio, and feed the MinimOSD the data on the ground, getting a clearer OS
Read more…I really do not see any reason why I should have the MinimOSD on the plane/copter, if I use 433MHz telemetry radios.
Can't I just connect the 5V, GND, RX to the ground based 3DR Radio, and feed the MinimOSD the data on the ground, getting a clearer OS
Read more…I am using iOS devices (iPad, iPhone), and would like to use APM planner. But for this I need to convert the USB ground radio into network traffic.
Did anybody make a simple solution for this using either a cheap $7 solution like Arduino Nano + ESP826
Read more…Does RCMAP work or not ? My Devo 10 with DeviationTX and RX615X will always output Throttle on channel 1 no matter how I reorder channels. Using a Walkera RX703A receiver, I will get the output on the right channels. So to use the RX615X, I need to r
Read more…