Gender
Male
About
Location
Roland, OK
About Me:
I'm 15 years old and from Oklahoma.
Please tell us a bit about your UAV interest
I have been flying Rc airplanes conventionally for a couple years and have just gotten into FPV/UAV type flying this year.
Hometown:
Roland
Activity Feed
"Hi, the plug with 4 wires needs to plug into the balance board of your charger. Then, depending on what adapter you have you may plug any one of the 4 other wires to the charge leads of your charger. Set the charger for LIPO BALANCE, 11.1v(3s), 1A.…"
Hi, I have APM 2.5 installed in my Skywalker X8. It is powered by the 3dr power module and the servos are powered by a separate BEC. I am getting servo jitters and jerks in all modes for some reason and cannot seem to isolate the problem... I am…
"I vote for new board with capability of separate video battery monitoring, bigger processor, and support for 2 cameras being able to switch between them!"
"I think the horizon panel could look much better if it were just dots instead of a blocky line across the screen. That way it wouldn't take up as much space on the screen either!"
"Hi, on the new visible sats panel, what do the extra 3 digits display?"
"Hi I have a problem here... I had apm 2.5 and minimosd working perfectly on my old skywalker but then I crashed it and totalled it. I have just now got everything transplanted in an x8 and everythings working good on the OSD except for the GPS... It…"
"What I did was twist all camera wires and I bypassed the osd with the positive wire and powered the osd with the 5v on the other side. So only video and ground is connected to the osd"
"No, I sent it back to 3D robotics... They said it is an issue with a bad batch of voltage regulators on the boards"
"Hi my APM 2.5 is now failing to boot on 2.70? Was working fine on 2.68 but now it doesn't work with either one! Nothing has changed except the firmware on APM and the new MP updates. LED C remains solid the whole time. It connects to MP but doesn't…"
"Hi my APM 2.5 is now failing to boot on 2.70? Was working fine on 2.68 but now it doesn't work with either one! Nothing has changed except the firmware on APM and the new MP updates. LED C remains solid the whole time. It connects to MP but doesn't…"
"Before you switch cameras, try twisting the wires going from the camera to the osd. I had the same problem and it fixed mine!"
"Did you get this resolved as I am having the same problem. Was working fine... Now it won't initialize"
"Hey did you ever fix this? The exact same thing is happening to me also"
"Nevermind guys I just realized I'm a dumbass. Didn't see the little check box on OSD config tool that said "Home Alt" XD"
"Surely someone has got to have something..."
