Gender
Male
About
Location
Type a choice below ..
About Me:
Physicist at the Institute of Intelligent Systems for Automation, National Research Council, Italy
Please tell us a bit about your UAV interest
cooperative air, land and sea UAVs Got a bixler 2 and a ros-pixhawk-based quadcopter
Hometown:
Bari
Activity Feed
"I wrote to 3DR few days ago for the same problem. Here follows Chris Anderson reply:
"Thanks for the note. Right now we're only selling the core Pixhawk elements, because the other parts are available from so many other sources (that's good-- it's…"
"Thanks for the note. Right now we're only selling the core Pixhawk elements, because the other parts are available from so many other sources (that's good-- it's…"
"Hi,
I would like to try the same trick on a BLHeli 12a...but I don't know which are the two bits to be removed..."
I would like to try the same trick on a BLHeli 12a...but I don't know which are the two bits to be removed..."
"Hi,
Very good job...could you tell me the flight time obtained with this setup?
tks!"
Very good job...could you tell me the flight time obtained with this setup?
tks!"
"Solved,
I've reversed the steering and the throttle channel on the calibration tab of APM planner (I have read somewhere that this should have worked)
thank you!"
I've reversed the steering and the throttle channel on the calibration tab of APM planner (I have read somewhere that this should have worked)
thank you!"
"Hi,
I am experiencing the same issue.APM planner works well with APM:rover on Pixhawk, while on Qgroundcontrol I get "unsupported command 252" message every time I try to start a mission. I also tried the launch button and I get Unsupported command…"
I am experiencing the same issue.APM planner works well with APM:rover on Pixhawk, while on Qgroundcontrol I get "unsupported command 252" message every time I try to start a mission. I also tried the launch button and I get Unsupported command…"
"same happens to me. Runs fine in manual mode, does nothing in auto mode.
Pixhawk with latest stable firmware (2.47)
Spektrum dx6i
RCMAP: thottle on channel 2 (left stick)
steer on channel 1 (right stick)
7 satellites found
3 WP…"
Pixhawk with latest stable firmware (2.47)
Spektrum dx6i
RCMAP: thottle on channel 2 (left stick)
steer on channel 1 (right stick)
7 satellites found
3 WP…"
"well, I think everything was correctly set, but we tried the bixler only one time..."
Hi,this is my bixler 2 setup. I still have to balance the model.Do you think iseverything okay or do you have any suggestion/observations, before I go for the first fly? thank youCAM00458.jpgimage.jpg
