Gender
Male
About
Location
MAKATI CITY
About Me:
bored mechanical engineer
Please tell us a bit about your UAV interest
anything about multirotor uav...
Activity Feed
With all the parts from arduplane and arducopter lying around, i decided to make my 9month old daughter a toy to chase around. Parts:-ardupilot w/ atmega328-3pcs 9g servo (2 converted for continuous rotation)-maxsonar LV-EZ0-quadcopter frame and…
"thanks. haven't noticed it in hobbyking. now baught sizes 3-6 to test with my 10g 2000kv motors. what test did you do to determine where to put those tapes?"
"may i know where you bought those counter props?"
"cool!!! if only someone could put the arducopter configurator screen on the tgy screen then everything would be very cool."
"the scale of the files are 1:1. i checked it a few days ago. please change your cad's units into metric. the mainsqre if i an not mistaken is approx 110mmx110mm."
"@ Chandan Roy
did you edit it with notepad as i mentioned?
After my edit, i tried the files with autocad 2000 to 2010 as well as volo view 3 and dwg trueview 2011 and all dxf files are viewable. please make sure you have downloaded the raw…"
did you edit it with notepad as i mentioned?
After my edit, i tried the files with autocad 2000 to 2010 as well as volo view 3 and dwg trueview 2011 and all dxf files are viewable. please make sure you have downloaded the raw…"
"@ sandro
i noticed that the solder jumper on the mag is still on 3.3V. I've read here that we have to change the jumper to 5V if connected to the I2C port at the back of that port. may i know if the "no gps" port is 3.3V? thank you"
i noticed that the solder jumper on the mag is still on 3.3V. I've read here that we have to change the jumper to 5V if connected to the I2C port at the back of that port. may i know if the "no gps" port is 3.3V? thank you"
"@ Chandan Roy
to open the dxf files uploaded by Jani using autocad or any viewer, just edit the dxf files using notepad. delete lines 26 to 49 shown below:
26 ENDSEC
27 0
28 SECTION
29 2
30 TABLES
31 0
32 TABLE
33 2
34 LAYER
35 70
36 1
37 0
38…"
to open the dxf files uploaded by Jani using autocad or any viewer, just edit the dxf files using notepad. delete lines 26 to 49 shown below:
26 ENDSEC
27 0
28 SECTION
29 2
30 TABLES
31 0
32 TABLE
33 2
34 LAYER
35 70
36 1
37 0
38…"
"Blue would be great.
In the setup shown on the photo, can the built-in ftdi of the shield be used for the Ardupilot Mega too?"
In the setup shown on the photo, can the built-in ftdi of the shield be used for the Ardupilot Mega too?"
