Gender
Male
About
Location
London
About Me:
Working in mobile tech
Please tell us a bit about your UAV interest
Interested in AP (Aerial Photography) and unmanned vehicles (planes and quads). The variety of skills required to assemble this UAVs (electronics, computer programming, flying skills) is also another element that interests me a lot
Hometown:
London
Activity Feed
"Progress:
Telemetry connected to the xbee pins 2& 3 and 10 (GND) plus power from i2c
Extend power headers done and working OK
Extend board and GPS working OK.. even from a window i get 4 satellites!
Radio RX and the air senson next ..."
Telemetry connected to the xbee pins 2& 3 and 10 (GND) plus power from i2c
Extend power headers done and working OK
Extend board and GPS working OK.. even from a window i get 4 satellites!
Radio RX and the air senson next ..."
"Also I am using a Futaba 8FG what would be:
TX_set2 or TX_standard on Config.h?
Worst case i will try this weekend with the transmitter as the weather in London will be awful...
Ta"
TX_set2 or TX_standard on Config.h?
Worst case i will try this weekend with the transmitter as the weather in London will be awful...
Ta"
"Same here ... for the 3DR Radio ..."
"Hi,
I am in the process of putting together a similar setup but adding 3DR Telemetry, an updated MPXV7002DP speed sensor and using the AIOP Extend Board for GPS.
My assumptions and questions are as follows:
a) Power needs to be supplied by the…"
I am in the process of putting together a similar setup but adding 3DR Telemetry, an updated MPXV7002DP speed sensor and using the AIOP Extend Board for GPS.
My assumptions and questions are as follows:
a) Power needs to be supplied by the…"
