About

Gender

Male


Location

Santiago, RM


About Me:

Mr, live in Chile South America


Please tell us a bit about your UAV interest

I like very much UAV, I have the Phantom FC40 and the flying wing Phantom FX61 with Pixhawk equipment and EzUHF


Hometown:

Santiago


Activity Feed

Sergio Vial replied to Sergio Vial's discussion Pixhawk Power module problem
"Do you have the 3DR model or a clone?"
Mar 16, 2015
Sergio Vial posted a discussion
I have the Pixhawk AP with power module. The problem is that the Power Module shows a extrange behavior, every time I connect it, shows in the Misiion Planner and the OSD (Minim OSD) the correct voltage (12,5 to 12,6 V on a 3S LiPo batt), but once…
Feb 28, 2015
Sergio Vial replied to Steve Cain's discussion Pixhawk PWM input for RSSI (EZUHF)
"I am not sure, but eventually I chose the link quality on chanel 8, so I cannot understand why it shows reversed on the Minim osd, but I will repeat the procedure to be sure before complaint.

Regards"
Dec 18, 2014
Sergio Vial replied to Steve Cain's discussion Pixhawk PWM input for RSSI (EZUHF)
"Rob: did you solve the problem of inverted values?, in my case, RSSI and Link Qty gave me the same inverted numbers, big number for transmiter off, and small one for full signal, your experience with this matter would be frankly appreciated."
Dec 12, 2014
Sergio Vial replied to Steve Cain's discussion Pixhawk PWM input for RSSI (EZUHF)
"Dear David, I follow up every step on your video, I have the same or even newer firmware in the Minimosd, but the RSSI appear lower when the transmiter is on, and higher when the transmiter is off, so the Link strengh is near 0% when is full strengh…"
Dec 12, 2014
Sergio Vial commented on Randy's blog post ArduCopter 3.2 Released
"Dear Friends, do you have any problems to update this las firmware versión via Mission Planner?, I do, I repeatedly obtain the same error message: ""
Dec 9, 2014
Sergio Vial replied to Lloyd DeForrest's discussion Unable to update firmware using the Mission Planner
"dear friends: I have installed on my PC (Windows 7) the  Mission Planner 1.3.16, and when I try to upgrade the firmware from my HK 32 autopilot (Pixhawk clone), with the last firmware available (3.2.0) from Ardu Plane, it fails and put the…"
Dec 9, 2014