Gender
Male
About
About Me:
Just looking around
Please tell us a bit about your UAV interest
dnsright.com
Activity Feed
Perth photographer’s beach sprint to catch falling drone caught on cameraTREVOR PADDENBURGPERTHNOWAPRIL 21, 2015 7:30PMIT is every drone owner’s worst nightmare — the batteries going flat over the…
"I am interested!
where is the link?"
where is the link?"
"Also if I upload the SkyWalker pram file from google code the altitude is about 1500m out.
Seems weird"
Seems weird"
"I also have a APM1280 and I get the same thing so I dont think its a hardware issues unless its the oilpan.
I am using the APM Planner 1.0.49 with the firmware it uploads to the board."
I am using the APM Planner 1.0.49 with the firmware it uploads to the board."
Hi All, I have been flying the SkyWalker with great success. However when I reboot the APM (2560) I lose the configuration. It keeps the waypoints but the configuration goes back to a default setup. This happens if I press the reset button or remove…
Hi All, I have stabilize and FBW_A working well however when I change to RTL the plane returns close to home then gains altitude and drifts with the wind. The attached picture shows the plane's path drifting with the wind. Can someone help me tune…
"Found it - Its inthe APM_Config.h file if anyone needs to know."
"Hi All,
I have been doing some testing - I have 2 APM and 2 Oilpans, both oilpans work fine however only one APM works. The 1280 APM works and the 2560 one doesnt sense the voltage.
How do I troubleshoot to APM.
Cheers
SImon"
I have been doing some testing - I have 2 APM and 2 Oilpans, both oilpans work fine however only one APM works. The 1280 APM works and the 2560 one doesnt sense the voltage.
How do I troubleshoot to APM.
Cheers
SImon"
Hi All, I am having an issue with the voltage sensor – I just cannot seem to get it to read a voltage. It always displays 17.8 volts. I have installedan AttoPilot Current Sensor Board. I am using the monitoring number 4 (currentand voltage). I can…
Hi All,I am using the throttle fail safe and have it configured and working. The issue I am having is I dont know how to change the modes.If I test the failsafe in the CLI it works but its using FBW_A. I would like to use RTL as the failsafe mode.I…
Hi All, I have stuck a ArduPilot Mega to the side of my Trex450 to see how it performs with the vibrations. I noticed a lot of drift from the IMU, for example if I change the pitch and only the pitch I notice the IMU thinks it is rolling as well.…
"Well done guys!!!
Just got the first download!"
Just got the first download!"
"Great Stuff!!
Well Done!"
Well Done!"
