Please help!
Hexacopter, APM 2.5 Controller 30 Amp esc Simo, 750 Kv motors.
The symptom: 1-2 minutes after take-off during stabilized flight, the right and left tilt, jolt, but kiegyenljti. I attach the logs. If anyone can help me some advice, thank yo
Greetings to all!
Please help.
I replaced the receiver hexacopteren (Hitech optic7 + -> + Turnigy 9xr orange) and after arming the motors do not start at the same time. What can be the reason someone?
APM 2.73 firmware, I have included the logs
Joe
APM 2.5 for FY680's installed in a frame. I installed the motors, power supply, and radio. I tried setting on the radio but did not appear in the green line on the screen. The radio works because it is tied to a servo and works. Who was exchanged for
Read more…I need help
How to wire canon sx230 hs for the APM 2.5.
I want to be with a USB cable and turn on for 4 seconds each do a picture. I uploaded it to the chdk started to get along, and the interval program., which itself works great.
I can create a usb ca
Hello everybody! I need help. APM 2.5 is not going by plane to mark the servos, 3 only channel with the engine. The Y cable was bad, it was broken when you moved it pulled the servos. I changed, but it does not work, just the engine. What should I do
Read more…Hi!
If the RC transmission is interrupted, the APM 2.5 robot switch circling mode, where you can turn off this ?
Please help!
Joe
Read more…Hi!
Work with the APM2 the optical flow sensor?
Regards
joe
Read more…I have a hexacopter APM2. I have placed on an optical sensor.
Up and a red LED is on and there was nothing else he was doing. Can someone help?
The parameters I have enabled (FLOW_ENABLE 1)
Joe
Read more…Hi!
What is the reason that sometimes AUTO mode without any operation Circkle mode
Read more…Hi!
Can you help someone ?
Radio and telemetry in I gave, and I do not know to set the stabilized mode moves very slowly, because the servos
APM1, Arduplane 2.24 and 2.33 Although it acts.
Joe
Read more…Hi!
When will it be available 3DR RadioTelemetry Kit-915 Mhz?
Would have to be urgently.
Can someone help? ?
Joe
Read more…Get help. The number of do_set_relay command parameters. 2 in the manual (the number of the relay, on / off) of APM in an on / off) with good
Read more…Help me! After initialization, only the B LED is lit continuously. Can not connect to cable sem.Nagyon slowly read the parameters, but then throws an error. What to do? ARDU I killed for? Welcome Joe Sorry for the lack of English for knowledge:)
Read more…