Gender
Male
About
Please tell us a bit about your UAV interest
I am a Hobby Pilot and developer.
Hometown:
bufapst
Activity Feed
"I forgot to mention that at first i was using the futaba training cable, but i noticed in forums that many reported an issue with the 9XR and Futaba training port (PPMSIM related?), so i have switched to the pins.
Either case, If i connect a servo…"
Either case, If i connect a servo…"
"Thank you for your reply.
The jumper from ch2 and 3 should be done also on the pixhawk?
the Dragonlink receiver v2 i have has its PPM on CH12 (older versions on CH 9 at least to what i understood), the 9XR setting should be 8CH as for the max…"
The jumper from ch2 and 3 should be done also on the pixhawk?
the Dragonlink receiver v2 i have has its PPM on CH12 (older versions on CH 9 at least to what i understood), the 9XR setting should be 8CH as for the max…"
"Hello, i have followed your setup, i am using dragonlink v2 with turnigy 9xr and seems like the PPM is not working - if i connect anything to channel 4 then its moving it (instead of the 12 CH for ppm).
- PPMSIM and TRainer are ON on transmitter.
-…"
- PPMSIM and TRainer are ON on transmitter.
-…"
Hello Pilots I am trying to do Radio calibration for my new pixhawk on Mission Planner and QGroundstation. I'm getting error message on Mission planner: "Radio Control is no active or turned on" - Dragon link v2 receiver is connected via CH12 PPM…
