Hi,
i want to test the PX4FLOW sensor with AC3.3 and was connecting everything according the WIKI.
In addition i addded I2C splitter and Compass with GPS.
do i have to change the I2C Adress for the Flow sensor and what should i set ?
What adress is the
Read more…Hi,
i want to test the PX4FLOW sensor with AC3.3 and was connecting everything according the WIKI.
In addition i addded I2C splitter and Compass with GPS.
do i have to change the I2C Adress for the Flow sensor and what should i set ?
What adress is the
Read more…Good Morning,
any idea ?
thanks
Thomas
Read more…hi,
i have problems with my barometer on px4 running 3.1 version.
althold is not working and from cli i see the following.
any idea how i can fix this ?
tahnsk
Thomas
Hi,
I need tomorrow position hold to lift some RC paracutes.
could someone tell me what was the latest release supporting this flight mode ?
i'm running px4 octa quad
thanks
Thomas
Read more…Hi
I had a small crash this morning while testing some video shoots with my Y6.
APM2.6 ublox GPS with external mag, Rctimer HP4108-380kv top props 13x5,5 bottom 15x6,5 + 40A rctimer ESC.
frame type 10.
4.5 kg with 5 S 5800 and Nex7 with gimbal hover curr
Read more…Hi all,
i had a crash today with my quad with the following components:
3dr APM 2.5 + 3dr GPS with external MAG + 433mhz telemtrie
Futaba R617S
4 x Rctimer HP4108-480 KV with rctimer 40A opto ESC
BEC standalone.
90A voltage and current sensor
while doing so
Read more…I have received my 2 pixhawks :-)
The first one is working fine, i have upgraded to 3.1.1 without any problem.
But the second one has issues to boot :-( i did the same procedure as on the first one but after the upgrade i get startup tone disturbed by
Read more…Hi all,
for unknow reason my tricopter crashed yesterday during FPV flight.
since i don't have much experience with this please help me to find out what happend.
The crash was between line 5500 - 5600 :-(
Thanks
Thomas
Read more…Hi,
I hope someone will be able to help me here :-) i have postet this yesterday in the airframe design, maybe wrong categorie..
Since i'm not happy with the Stock frame setup (doesn't fit to my frame) i decided to start making my own Motor Layout.
here
Read more…Hi,
I hope someone will be able to help me here :-)
Since i'm not happy with the Stock frame setup (doesn't fit to my frame) i decided to start making my own Motor Layout.
here the frame
The Box in the middle is the APM and the CG.
here the defaults for t
Read more…Hi,
i'm buildung a new foldable V-Frame at the moment and looking for the best location of the APM.
Could anyone advice ? or is there any documentation ?
Thanks
Thomas
Read more…Hi
I almost crashed my X8 yesterday after failsafe setup...
I started in stabilize and after a few sec. i switched to pos/hold and the copter started to fly away..
switched to loiter but no success, back to stabilize i was able to get control but the ve
Read more…Hi,
I'm pretty new to arducopter and my second copter has a Octa_quad X frame.
I have changed the apm_config.h with the frame parameters.
my problem is now that i don't see any radio input after i compiled and uploaded via arduino.
did i miss something a
Read more…