About

Gender

Male


Please tell us a bit about your UAV interest

Basic Quad on the cheap


Hometown:

Harpenden


Activity Feed

Tim Arnold replied to Tim Arnold's discussion My Latest Version Of Mission Planner has lost the Terminal
"Yes thats exactly what I do, com3 then I get this message"
Aug 19, 2014
Tim Arnold replied to Tim Arnold's discussion My Latest Version Of Mission Planner has lost the Terminal
"OK but how do we run them please?
Also I am getting a message when I try to download firmware Screen Print"
Aug 19, 2014
Tim Arnold replied to Tim Arnold's discussion My Latest Version Of Mission Planner has lost the Terminal
"Sorry to br dumb but I don't know where that is. Oh yes I do, found it.  But how do I do a complete delete so I can do a clean re install? Will clicking on Uninstall MP do that?"
Aug 18, 2014
Tim Arnold posted a discussion
Hi after a break of about 6 months I decided to start quad flying again so fired up MP.  I duly updated to the latest version 1.3.7 build 1.1.5307.24027. My problem are 1. I cannot see the Terminal tab. 2. having updated to the latest firmware I now…
Aug 18, 2014
Tim Arnold replied to Tim Arnold's discussion RTL Power Dive resulting in crash
"Now I have had a chance to go over this incident I think I made a fundamental error in set up.  I used a PM to power the board but I did not follow the instruction to power the servo rail from the esc.  I had all 3 wires from the esc plugged into…"
Nov 29, 2013
Tim Arnold posted a discussion
I wonder if one of the experts could have an analysis of these flight logs and tell me what caused this behavior.SpecPlane = Skywalker 168RC Futaba 8fg Tx Corona 2.4 RxAPM 2.5 downloaded with parameters for Skwalker from wicki3d battery monitorset…
Nov 23, 2013
Tim Arnold replied to robbie knowles's discussion external led on arp2.5 in ArduPlane User Group
"IS it going to be put into Rduplane?  It seems pretty important to me as most of us have the APM buried inside the model."
Nov 16, 2013
Tim Arnold posted a discussion
Sorry if this seems a basic question but can anyone tell me where I plug the pan and tilt analogue servo leads into?  Is it into the "Outputs" or is it into the "A" side of the board?
Sep 30, 2013
Tim Arnold replied to Brad Cameron's discussion Finally got Arducopter 3.0.1 working amazingly!
"Which external compass did you buy?"
Sep 30, 2013
Tim Arnold replied to Jan Willem's discussion DO_SET_ROI / ROI : Howto use this option?
"I also struggled with this. I wonder if you have to set an area as a Point Of Interest.  I so, how is this done?"
Sep 21, 2013
Tim Arnold replied to Steffen Kupka's discussion APM 2.5 Super simple mode on ch7 or ch8
"In fact I cannot seem to get the Simple or Super Simple modes to work at all even if I put it as one of the standard 6 modes.  Anyone else?"
Sep 15, 2013
Tim Arnold replied to Steffen Kupka's discussion APM 2.5 Super simple mode on ch7 or ch8
"Me to, simple and super simple do not work unless the copter is in a failsafe rtl, or geofence rtl???"
Sep 10, 2013
Tim Arnold replied to Alberto Mennella's discussion 3.0.1 compass test
"I dont know if its related but i am having similar issues with a 2.5 in that it flat refuses to setup the compass radio and gps. If i reinstall 2.91b all is good."
Aug 18, 2013