About

Gender

Male


Location

Nykoping


Please tell us a bit about your UAV interest

Fascinated of what technology is capable of doing in the matter of UAVs. Have taken the step from a Feytech controller to the APM2.5 on my Quad.


Hometown:

Nykoping


Activity Feed

Tobias Halldin replied to Elvis's discussion ArduCopter Level Strange Message
"I am experiencing this too. Have tested with both mission planner 1.2.46 and 1.2.47"
Apr 26, 2013
Tobias Halldin replied to Tobias Halldin's discussion Power cycling APM2.5 returns to default
"This picture below shows the values it takes when I have done a "erase" from the cli.
And when changing stab_p to 0 and pressing "Write Params" and then "Refresh Params" it takes the new values no problem.

But after disconnecting the USB to APM and…"
Jan 26, 2013
Tobias Halldin posted a discussion
I have a problem when upgrading to the new 2.9 firmware.When changing Stab_P to 0 for tuning.After power cycling the APM it will load the default Stab_P = 4,5.Have tried reflashed firmware on the APM 2.5, erased EEPROM but nothing.Any thoughts on…
Jan 25, 2013
Tobias Halldin replied to Ioan Ghip's discussion "factory default" values?
"Enter the CLI mode. I think it says "Terminal" in Mission planner.
Type "setup" and then "erase"
That will reset all values to default.

Maybe someone can fill me in on the command for "Factory reset", I dont really understand the difference."
Jan 25, 2013
Tobias Halldin replied to Randy's discussion ArduCopter 2.9 / 2.9.1 released
"Hello all and thanks for continuing the development of arducopter software.Howewer I am experiencing a problem after the 2.9 upgrade.When changing Stab_P to 0 for tuning.After power cycling the APM it will load the default Stab_P = 4,5.Have tried…"
Jan 24, 2013
Tobias Halldin replied to Randy's discussion ArduCopter 2.8 / 2.8.1 released
"First of all, big creds to the team !

Arducopter 2.8 works marvelous in today's test flight.

A question though, with the I term moved to Rate controllers, do I need to adjust Stabilize_I ?
The setting is still in mission planner though the default…"
Oct 22, 2012
Tobias Halldin replied to Scott Berfield's discussion Does this look right for Sonar?
"I have tested the new LV-EZ0 today in about 10C temperature outside.
The results are really good !
Didnt have to touch the throttle for the whole flight. There is some variation in altitude but I think that's an arducopter setting because the sonar…"
Oct 10, 2012
Tobias Halldin replied to Tissy's discussion Calibrating Sonar
"I noticed this from the datasheet of EZL0:
Each time after the LV-MaxSonar®-EZ0™ is powered up, it will calibrate during its first read cycle. The sensor uses thisstored information to range a close object. It is important that objects not be close…"
Oct 10, 2012
Tobias Halldin replied to Scott Berfield's discussion Does this look right for Sonar?
"It seems to be some spikes, but does it fly well with that ?
I have a even worse problem, here in sweden it starting to get chilly outside and as soon i take the quad outside and put it into ALT_Hold it starts to climb away.The logs says it's…"
Oct 8, 2012