Gender
Male
About
Location
Summersville, WV
About Me:
Professional Surveyor-Licensed in West Virginia and Ohio
Please tell us a bit about your UAV interest
Getting started with 3dr quad for aerial surveys, videos etc for recon, real estate and commercial construction projects. Plan on doing aerial mapping, smaller projects with quad and Canon 260
Hometown:
Summersville
Activity Feed
"Thanks Matthew,
I'll give that a try.
Much appreciated"
I'll give that a try.
Much appreciated"
"Thanks John,
I had attempted in the past to use Mission Planner, but it failed to update. I notice others have had same problem in the past and suggested using custom download, but another mentioned need to be sure have the right "hex". Not sure of…"
I had attempted in the past to use Mission Planner, but it failed to update. I notice others have had same problem in the past and suggested using custom download, but another mentioned need to be sure have the right "hex". Not sure of…"
My 2013 RTF 3drobotics 2013 quad does not seem to recognize spline waypoints. The APM 2.6 has the original firmware, is this the problem.The quad recognizes the take off and climbs to altitude and just hovers, have to go back to manual to retrieve…
"I have a 2013 3drobotics quad I would like to mount a gimbal, does anyone have a simple mount process. I would like to use a canon 260 for video
Tom Gates"
Tom Gates"
"Gimbal,
I have a 2013 3drobotics quad, does anybody have a gimbal mounted on one of these. I would like to mount a gimbal I can use a canon 260 for video
Tom Gates"
I have a 2013 3drobotics quad, does anybody have a gimbal mounted on one of these. I would like to mount a gimbal I can use a canon 260 for video
Tom Gates"
Ok, I have been attempting to update quadcopter firmware to 3.1.5 without any success. Problems with download, I was told it might be the usb cable, so used another one with the same result.My setup goes like this, quadcopter connected to pc with…
"That is something I have never seen on the pull down in Mission Planner, it does show in Windows Device Manager, as to evertime, I don't know. I have always had to use com13 115,200, of course the com just happens to be the one I am plugged into.…"
"Thomas,
Saved my parameter list and clicked INSTALL FIRMWARE, picked QUAD3.1.5 and waited for it to "check board version", waited some more, starting downloading, then came up with "communication error"-connection failed. Tried three times with no…"
Saved my parameter list and clicked INSTALL FIRMWARE, picked QUAD3.1.5 and waited for it to "check board version", waited some more, starting downloading, then came up with "communication error"-connection failed. Tried three times with no…"
"Yeah, I've been looking, just have not found the one...at the price...if you know what I mean."
"That looks good for the ground station, still can't find a box for the 3d robotics quad with extend legs, at least not at a price I can bear."
"Check this link
http://planner.ardupilot.com/wiki/common-using-the-3dr-radio-for-te..."
http://planner.ardupilot.com/wiki/common-using-the-3dr-radio-for-te..."
I have a 3d robotics quad and FLYSKY transmitter, RTF from 3D robotics.I have a understanding of the six flight modes and using RC 6 knob for servo on camera mount.I see from the Mission Planner CH 7 has been setup as the Save Waypoint feature.I can…
