I have made a balsa glider with following specification:
Aerofoil : Clark X
Dihedral Wing (2m)
Pusher Configuration .
Rudder and Elevator
I m facing a problem of thrust torque , As I increase throttle, bird goes leftwards . So to correct this i trimmed m
Read more…Dear all,
I was using a 40 MHz T6EXP Futaba transmitter in PCM mode with the PCM Receiver of same frequency R13P 6 channel Futaba Receiver with 40 Mhz crystal. Just few days back i lost my receiver , and could not find the same av
Dear All,
I had made a balsa mosel of pusher configuration with the poluhideeral wing span of 1.6m.
I had just done a flight test today and recorded some observations.
1. I did a hand launch , plane dives when throttle is more than 3/4.
Hi all,
I m using Futaba 6 channel PCM Transmitter(T6EXAP). It has a two way switch on channel 5, which i want to upgrade to three way switch for my autopilot controls.
Currently in upward position signal width at reciever is 1936(
HI all,I m on developing a GCS on the basis of rotation matrix elements. Is it possible to display the roll and pitch on the basis of rotation matrix at the output . I m using Bill's UAV DEVboard and getting rmat data at output .After little analysis
Read more…HI all, i had tested my ardupilot code and it was successful also , next updation i would like to add kalman filtering concept in currently available code..so is there any body have any experience with kalman filtering or any reference material which
Read more…Hi all , i have little doubt in changing GPS Baud rate. Currently its working in binary SIRF protocol in 57600 baud rate.. I would like to change it into 19200 baudrate. So i made few changes in 2.0.1 code and tested it but failed to get the GPS lock
Read more…Hi all, i m ready for the ground test.Before starting i would like to clarify few things here..I dont have Z sensor and air speed sensors soofcourse no throttle control then also... I was ok with version 2.0 but since i would like to add the config u
Read more…Just recently i got the ardupilot atmega328 board. It worked fine i test the version 2.0 and 2.1 on it. It worked nicely. But from past two days i could not load the program in my board it shows the message STK500 protocol:: not in syncExpected reply
Read more…