Gender
Male
About
Location
goole, east yorkshire
About Me:
im male 43 from east yorkshire in the uk. im a bit of a rc geek, boat,planes,helis,cars. done them all.
Please tell us a bit about your UAV interest
i have a quadcopter with a gopro mounted. looking to get into aerial videos and photography.
Hometown:
goole
Activity Feed
Hi all I have my quad with a gopro camera and a minimosd. im using my goggles and fpv monitor. In the top left hand corner in getting the gopro video symbol in a white box and a 1080 the same. It can't see the information from the osd in that corner…
"Cam did you get your throttle failsafe working, for the transmitter? I'm having the same problem"
"Thanks John I'm on the old 9x firmware not the erx but ive just bought a 9x pro, so i can certainly use the settings on that.I'm using aux 3 flap 3 possible switch and the gear swith."
Hi all im trying to programe the 6 flight modes for my apm 2.6 quad on my Trunigy 9x Tx.i have followed the instruction to a tee.. but im only getting 3 modes.gear switch back and go thru flap switch i get no modes, only mode 1 then i put the gear…
"Thanks Gary... I originally used my old apm 2.5 that was set up on a different quad and it hovered great. Until you put a stick movement in and it drifted and lost altitude until it found the ground. I thought maybe this new apm was faulty or…"
Hi all I have never built a quad before. I have had a pre built one tho. So I have built the quad. I'm using apm.26 to which I have done nothing. Built the quad installed all the radio gear and that's it tried powering it up and turned on trannie…
"Does that mean its hard to do with my controller. Even if I can just set it pointing down.not too bothered about using transmitter to set it during flight?"
Hi all i just got a AGM Gimbal for FPV and Aerial Photography. I believe it has a Martinez Control Board. What i need to do is set the camera facing down slightly as standard rather than it looking straight infront. is it possible? also if it can be…
Can anyone tell me what i need to do ....? i want to connect some lights to my quadcopter they have a servo lead plug on the end of the controller.from what i gather i can plug that lead into the output port on my APM.2.5 and assign a switch on my…
"I found out by giving it a go, yes i can plug the lead into my reciever and they work. but i cant turn them on and off by a switch on the transmitter."
Hello everyone. i have just bought some led night flying lights that i want to put on my quadcopter. the instructions say i can use my reciever battery to power them or a seperate battery at 4-6v. can i connect the lead on the control unit to my…
Hi all I have just bought a single TTL 3DR radio telemetry setup.I have plugged the air radio in to my quad via a cable into my APM2.5 and the ground radio into my computer using flight planner. the computer recognises the ground radio and I have…
"Im thinking of the wing angle and not the horizon."
"Sorry guys im loosing the plot. Yes it is correct and im mistaken. My apologies. Dont know why I got confused. Maybe as im not used to the flight planner interface."
"Hi mike
No its opposite. Im looking at it as if im in the pilot seat of the quad. If I roll an aircraft 45 degree angle of bank in a left turn. The horizon would drop to the left and go up on the right. On misson planner it going up on the left on…"
No its opposite. Im looking at it as if im in the pilot seat of the quad. If I roll an aircraft 45 degree angle of bank in a left turn. The horizon would drop to the left and go up on the right. On misson planner it going up on the left on…"
"Just had a thought. in the params can i adjust some settings to slow the quad down while in stabalize mode, in relation to forward and backward motion"
