"Quadcopterin gyro kalibrasyonunu düzgün yaptıysanız çok fazla bir tarafa çekmemesi gerek. Hafif çekmeleri de trim ayarlarıyla halledebilirsiniz.
Fakat pusula kalibrasyonunda beyaz noktaların çıkmaması normal değil. Gps ve pusula bağlantınız düzgün m…"
"Yes i can configure my m8n gps with apm passthrough.
My problem is; gps works perfect with ucenter but when i load firmware (3.1.5) again apm does not find any gps.I could not find any solutions yet."
recently i bought my minimosd v1.1 from chinese manufacturers. I connect my mobius cam as below but i got nothing but black screen.
in the meantime i never see green led blinking on minimosd. is it necessary?"
"I am using apm 2.6 board on a quadcopter.
I was able to download the log on 3.1.5. After loading 3.2 rc5 fw on terminal screen when i click the connect button it give me some words like calibrating etc etc. When i click log download button i don't…"
"There is not an obvius answer to this question but here are my suggestions.
1 - use a gps holder stand for reducing electromagnetic interferance (like this)
2 - wait 4-5 minutes before take off. if possible plan your flight with high number of satel…"
"We can't write because this board does't have eeprom. Maybe this is not crucial because apm configs ublox on every boot. If you still want to write settings, there are documents that describes adding eeprom on it.
But i am thinking to upgrade lea 6…"
"I have this type of ublox with compass module.
I tried lots of thing but i could not change any configuration with u-center software. Also config file gives error.
Is it essential to change parameters (baudrate, refresh rate etc) for autonomous flig…"
"I have same problem. I took off on stabilize mode, then switched to altitude hold and then loiter, there were no problems. When i switched to auto mode it flied away to sky :) up to 165 meter. Then decided to descend but then crashed. Luckily crashe…"