Gender
Male
About
Location
parana
About Me:
engineer land surveyor, aerial photography, GPS, topography, gnu linux user.
Please tell us a bit about your UAV interest
devices programming, open solution ( hardware and software ).
Activity Feed
"Hi Lior,
Hope you have solved Trimble iQ lassen raw data output.I started programming it but no success at moment.take a look on this thread:http://diydrones.com/profiles/blogs/centimeter-level-precision-gps-...
regards,
julio"
Hope you have solved Trimble iQ lassen raw data output.I started programming it but no success at moment.take a look on this thread:http://diydrones.com/profiles/blogs/centimeter-level-precision-gps-...
regards,
julio"
"Hi John Morris ! thx for your fast reply. i will go decode the 0x6D. I set TSIP ID=0x35 packet byte 3, bit0= 1, bit1= 1, bit3 = 1 enable raw. I sent TSIP= (byte0=0x13,byte1=0x02,byte2=0x00,byte3=0x0B), the receiver should return 0x55 packet but…"
"Dear all,
I have a Trimble iQlassen and i am trying to get raw carrier phase from it.I plan post-processing the UAV colected GPS data.I wrote some C code and sent the 0x35 to iQlassen TSIP port at 9600,ODD... taking care about Big x Little endian.I…"
I have a Trimble iQlassen and i am trying to get raw carrier phase from it.I plan post-processing the UAV colected GPS data.I wrote some C code and sent the 0x35 to iQlassen TSIP port at 9600,ODD... taking care about Big x Little endian.I…"
"Dear Noland.
I hope you have it up and running as your question was posted in 2010 .
I have an u-blox LEA-4T.
By hardware ublox can only accept input of RTCM messages 1,2,3 and 9. Code messages.
It would be possible to get centimeter with carrier…"
I hope you have it up and running as your question was posted in 2010 .
I have an u-blox LEA-4T.
By hardware ublox can only accept input of RTCM messages 1,2,3 and 9. Code messages.
It would be possible to get centimeter with carrier…"
