Gender
Male
About
Please tell us a bit about your UAV interest
beginer
Hometown:
new zealand
Activity Feed
"Hi Elad
thanks for writing up the code, its exactly what i was looking for, great work!
i have a couple of issues, the camera always zooms in when the stick is neutral, my neutral on radio is 1505 pwm.
i have tried adjusting the zoom in/out values…"
thanks for writing up the code, its exactly what i was looking for, great work!
i have a couple of issues, the camera always zooms in when the stick is neutral, my neutral on radio is 1505 pwm.
i have tried adjusting the zoom in/out values…"
"can see it only has one usart, can i use the spi port, or try find the rx/tx signals before they go into the usb converter?
thanks for your time, just a little lost, would like to use the leo stick if i can"
thanks for your time, just a little lost, would like to use the leo stick if i can"
"also i am using a leostick, is this why i get a error? do i need to change the ports?"
"Hi Rolf, here is my setup, i am using the D8R-2plus which i have flashed with XP firmware to enable cppm.. so sbus is just iverted , the D8R has 2 wire serial tx/ rx if i am not wrong? can i use your setup with the 2 wire serial i have instead of…"
"do i need to comunicate with the rx via sbus? can i not connect it via uart2 rx/tx via a level converter to the rx/tx on my receiver?"
"Hi all
i am using a DX8R II Plus receiver , re flashed with D8R-XP_CPPM_27ms firmware so i could get cppm from it. Question is, this reciever is not SBUS is it? i know it has hi level serial as this was the port i used to reflash with without a…"
i am using a DX8R II Plus receiver , re flashed with D8R-XP_CPPM_27ms firmware so i could get cppm from it. Question is, this reciever is not SBUS is it? i know it has hi level serial as this was the port i used to reflash with without a…"
"Thanks for your advice :) so when calibrating accelerometer etc, is left side looking front on or from the rear ? Ie like a car ? Would I be better just putting another 4 2215s?
Also from using the calc I father you need twice as much thrust as…"
Also from using the calc I father you need twice as much thrust as…"
"Hi thanks for the quick reply. I am using a 3s 6000ma , according to the specs on emax site they reccomended those props ? I am using 40 amp speed controllers , can you recomend a better motor without me having to run 4 more motors and speed…"
Hi, I am new to quadcopters, I am having a few issues. On take off my quad gets about 6 inches off the ground and starts to move so I correct it, it then starts moving foward and I loose control of throttle all together, still only about 6 inches…
