Gender
Male
About
Location
Kingsville, TX
Please tell us a bit about your UAV interest
i am developing a automated comtrol system using the pixhawk
Hometown:
hyderabad
Activity Feed
Hi everyone, I am relatively new to this stuff. I am running a SITL using mission planner and xplane 10. I was able to use it properly until yesterday on a helicopter. But, now i am getting a warning on mission planner :'bad accel','bad gyro'. When…
Hi, i am using my pixhawk on a helicopter model. i have seen that there is a data column called time stamp in the data. but, im having trouble converting this timestamp into millisecond time units. does anyone have a way to convert this time stamp…
Hi everyone,I am using pixhawk on my gas powered helicopter. I am planning to run some experiments on my helicopter. In these experiments, i am supposed to use a varying frequency, that is frequency sweep signals on each of the 4 control channels. i…
i am using a dx18 transmitter......i want to implement a custom built varying frequency input signal generated using matlab on my rc. does anyone has any ideas.., please suggesthere is an example signal in the imageif there is a way to use such a…
"i am actually able to connect a dx18 transmiter to pixhawk using only the satellite receiver. right now i can see the input and output variations in the mission planner status tab on the main screen. i have not tested it using the actual servos.…"
"thanks for the response man...it works great... :)"
Hi,i am using a vibe 50 nex helicopter setup with a DX18 transmitter and pixhawk. I am using this for research and analysis purpose. I am trying to use pixhawk as the controller. Done the regular firmware with the latest version. I have disabled the…
