auto-trim mode not work
since ver 2.0.27 i never can't set auto-trim level.(arming 20sec). on last ver is work well
my qc always drift to back.
but if i use manual level (disarm 10sec) its can work.
any idea?
mc_don's Discussions (8)
Sort by
declination question
hi,
i have finish test my copter
add compas.. and no need calibration like last ver :)
my question.
my coordinates now is:
Latitude: 6° 12' 41.6" S
Longitude: 106° 50' 42.6" E
Magnetic declination: 0° 46' EAST
Declination is POSITIVE
Inclination: -30° 57'
Magn
my GPS error?
is my GPS error?
see my pic.
i not move the QC. still on table.
but on AMP my QC look moved (blue line)
what must i do?
help me please
Read more…best solution for qc in the windy condition
I'm looking for the best solution for my qc.
I hope my qc will fly stable in the windy condition.
Does any body know what should I do with my PID configuration?
How about the motor & prop configuration? Should I use high KV motor or Low KV?
Which is bett
anybody not have yaw problem???? or only me??
I have no solution to solve yaw isu, until today
I've test to 3pcs ardu board, I use hexa and qc config
1. Hover mode is ok
2.I move it fast forward. After 10meters, the quad have yaw problem, the qc spin (about 90degre) by it self, And then it stop
NX-4006-530kv on arducopter
http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=17924
some one have test this motor?
can i use this motor on our arducopter board? (must change PID?)
how about flight duration? can i get more flight duration?
now i'm
Read more…ardu 35 test.. but.. yaw?? :((
upload from AMP. ver 35.
test on 3 board, 3 frame,3 remote and 3 rx
1. quad copter 28cm /arm, motor 1000kv 2820, prop 10x45,default PID
2. quad copter 40cm/arm,motor 1000kv 2820, prop 10x45,change IMAX from 50 to 100 default PID
3. hexacopter 28cm.arm
Read more…help... arducopter 2. fly in auto-trim mode
i try to set level on fly in auto-trim mode
and after trim my qc is very level..
but when i connect board to APM software.. and put my qc on the table
the accl sensor on APM is not on level position
this my print screen
so when i go to alt hold m
Read more…