"Hi Jani !! i already connected the distribution board as per your suggested but my mission planner cannot connect to APM 2.5 (Error ! Heartbeat Packets Received)"

"Hi Jani my distribution board have arrived !! any diagram or guide on how the connection to APM ??"

"What FC you are using ..? APM 2.5 ..?"

"MIne not function for the camera Roll and Pitch  gimble function on any Pin "

"Thanks Jani..!!"

"Greeting all i already purchased the ioboard telemetry distribution board from jdrones :)"

"Thanks Jani for the update i'll purchase it soon and yur new IObaord maybe .. :)"

"Hi Jani ! is the board out already .?"

"At last Thanks jani also been waiting for this device as yur ioboard is now working perfectly on my drone "

"when the telemetry ext will be out ..? or the I2C cable ..? cos now i'm using telemtry system"

"Still No Luck :( managed to installed the V-reg without any problem yet my servo gimble still not functioning the servo have signal its only move when i click the reverse tab on the APM "

"i'll try to rebind my Transmitter and informed you the result !!"

"my Rx didnt give any verifactions"

"yup when connected the red light on the back of the Transmitter is lit but if not detect the Rx the Blue led will blinking with beeping sound !! what shall i do ? bind my transmitter agian ?"

"No i havent measured the voltage coming out from the V-reg !
ok Jo this is the result of my APM configurations
When i turned my controller there's beeping sound on my controller ( Hitec Aurora 9) and after i connect Battery (3 Cell 5000mih) all my…"

"I already read the manual !! is it have to program the V-reg to set the Volt.?"