Gender
Male
About
Location
Inverness
About Me:
Studying Electrical & Mechanical Engineering at Nanyang Technological University & University of Strathclyde, Glasgow.
Please tell us a bit about your UAV interest
UAV is a new interest.
Hometown:
Inverness
Activity Feed
"When I connect power to my APM2.5, the leds ABC do not light up at all. I can contact the board through USB however. The ESCs are also not seeing the output pins except for pin 1. This has just occurred all of a sudden after several flights of…"
"Here is a short video of the problem I am facing
http://youtu.be/ufmlLzgbgYE"
http://youtu.be/ufmlLzgbgYE"
I have to demonstrate my quadcopter tomorrow for my university project, and suddenly it has stopped working.I power the APM from the Battery and not through the 3DR power module, therefore I have a jumper on JP1. I connect the board up, and the ESCs…
"Forgot to add, the test code returns port 0, but not port 3."
Hi, I am new to this, and I am trying to set up my xbee pro s1 modules. I have always obtained mavlink timeout in MP, and in X-CTU range testing I have 'timeout waiting for response'.However I am sure the modules are paired, as when I connected the…
After calibrating the ESCs on my copter, I cannot communicate between my Laptop and the APM1 board. I have tried 3 PC's so far. When I try and upload the firmware to the copter I get the folling message: Upload succeeded, but verify failed: exp 0…
