Gender
Male
About
Location
Saint Paul, MN
About Me:
RC flight, rock crawlers and scalers.
Please tell us a bit about your UAV interest
Bought the V2 purple kit to install in a Sky Surfer for aerial photography and videos.
Hometown:
Apple Valley, MN
Activity Feed
"OK- maybe this is it:
2015-01-18 15-56-07.bin"
2015-01-18 15-56-07.bin"
"OK- I think this is the proper log:
2015-01-18 16-22-58.zip"
2015-01-18 16-22-58.zip"
"OK- which log is that one (what extension)?"
Did one test flight of my upgraded Iris/Iris+. Before flying I recalibrated the ESC's and recalibrated the compass. Took off in STD mode and flew for about 2 minutes making sure everything was working OK. I then switched to Loiter and the…
"YES! That's what I had to do to get the full list. Thanks for mentioning that- I knew I missed something."
"Thanks for the tips. I already knew about the ESC calibration. The version of MP I have is 1.3.17 (I'm not using APM Planner). The link you posted takes me to version I'm currently using."
I'm finally getting around to upgrading my Iris to Iris+ and I having a problem with Mission Planner. When I open MP and click the Config/Tuning tab I don't see the Full Parameter List to install the new Iris+ settings. I connected the Iris with…
"Are you supposed to go through the recalibration process after installing new firmware? I didn't when I installed V3.1.4 and I just installed 3.1.5."
"Kevin- THANK YOU! Calibrating the sensors with the GoPro facing straight up and level solved the problem. I also reflashed V1.4 firmware for both the board and the motors. Ch6 knob for tilt control is also working. So far bench testing the setup…"
"Mike- I haven't done anything with the gimbal and motor firmware. From what I understand on the 3D Robotics Iris page the gimbal should already be configured. I'm doing a little research now on updating the gimbal and motor firmware.
mP1- I'm…"
mP1- I'm…"
"I checked all the screws, nothing is loose."
"Bruce- I centered Ch6 (according to the monitor screen on the TX) and the same thing happens.
Curtis- this is how the leads are wired:
I moved Ch6 knob all the way to the left and right- same thing happens."
Curtis- this is how the leads are wired:
I moved Ch6 knob all the way to the left and right- same thing happens."
I'm having some trouble setting up the Tarot gimbal on my Iris (ordered both at the same time). I set everything up according to these instructions:http://3drobotics.com/wp-content/uploads/2014/04/Tarot-gimbal-kit-I... and brown wires…
"I have a few of the Sky Surfers (same as a Bixler). One is a dedicated LED night flyer, one I modded with flaps and added a Ready Made RC camera pod (just the pod, no pan/tilt setup) and one with the DIY Drones electronics pod and APM2. For the…"
"I still can't get the radios to connect. Here's a screenshot of my com settings and Mission Planner settings. I don't see the settings for the air radio on MP."
"OK- I tried a different laptop and same results- the radios are not connecting. So what's next?"
