About

Gender

Male


Location

bangalore


About Me:

I am a Embedded Geek, a RC flyer by hobby. I am using my own autopilot for couple of my projects.


Please tell us a bit about your UAV interest

UAV embedded software development


Hometown:

pune


Activity Feed

satapathy commented on Kristaps Brass's blog post Comparing Precision of Autopilots for Survey Missions - Pixhawk with ArduCopter firmware
"Hi, Very good results ArduCopter firmware 3.4.6. Can we put a table of comparison for better understanding?"
Jun 25, 2017
satapathy replied to satapathy's discussion Exciting job opportunity at Asteria Aerospace
"The Opportunity is for people from India and Overseas. "
Jun 2, 2017
satapathy posted a discussion
Autopilot software development and controls - Following jobs are available for embedded software - GN&Chttp://www.asteria.co.in/embedded-software-engineer-gnchttp://www.asteria.co.in/sr-embedded-software-engineer-gnc
Jun 1, 2017
satapathy commented on LightWare - Laser Developer's blog post LW20 LiDAR - half the size, twice the performance, infinitely better.
"Ca you go down on the weight up to 5 grams? "
Oct 4, 2016
satapathy commented on DROTEK's blog post TINY RTK : The world smallest precision GPS ... and the cheapest
"Is there an option with PATCH Antenna on the PCB itself? I don't want to connect to an external antenna."
Sep 14, 2016
satapathy replied to John Hanson's discussion Relay APM2 Question
"Hi Zheng, I could see some hope fixing my issue after reading your post. I am using ardupilot 2.5 for plane. I have a camera and wanted to control its power via relay using ardupilot (A9) from mission planner. The relay circuit is ready and has two…"
Mar 27, 2014
satapathy replied to Oliver Volkmann's discussion Configuring "A9" on APM2.5 for Camera Trigger with StratoSnapper
"Hi Oliver, I could see some hope fixing my issue after reading your post. I have a camera and wanted to control its power via relay using ardupilot (A9) from mission planner. The relay circuit is ready and has two pins out +5V DIO signal and GND.
I…"
Mar 27, 2014
satapathy replied to satapathy's discussion Controlling video signal from Mission planner using arduplane
"Hi OG, you have shown nice video transmitter system but it doesn't serve my purpose. I mean I already have existing system with me  and I want to do software modification in Arduplane and mission planner so that I would be able to switch between…"
Mar 26, 2014
satapathy posted a discussion
Hi, I am using two camera (Day and Night) payload in my plane but I have only one video transmitter which can communicate to video RX connected to Ground station (GCS). Now I want to send one of  the video signal to video tx one at a time. To do…
Mar 26, 2014