Location
quebec
About
About Me:
i'm mechanical engineer
Please tell us a bit about your UAV interest
i do a project in hexarotor UAV
Hometown:
canada
Activity Feed
hello;i t's displayed bad gyro health in mission planner , i like to ask if the metal has an effect on the gyro, so it must put it away from the metal ?thanks
Hello;after doing the sensors and the esc calibration in mission planner; i observe that motors spin with a higher velocity at the minimum of throttle , this problem caused the crash of the hexacopter when i try to fly it .have you an idea about…
hello;i have the problem of the throttle at 10% is higher like this videohttps://www.youtube.com/watch?v=pNxQ77T4TE4how i can resolve this problem ?thx
hello;i like to connect the BLACK MAJIC DEBUGGER into pixhawk , i think that i must add this device http://media.digikey.com/photos/Sullins%20Photos/GRPB052MWCN-RC.JPG in the place of FMU SWD ARM MINI JTAG like this…
"how are you used Putty to read telemetry and the data of sensors ?
thx"
thx"
"how are you solved this problem ?
thank you "
thank you "
"hello;i did all the step in your tutoriel but when i did the command mavproxy.py --master="com14" --baudrate 57600it displayed logging to mav.tlog failed to load module maned misc failed to load module named terrain
please help me
thank you"
please help me
thank you"
"i like to send the velocity of motors and receive data of sensors"
Hello;i did the arming of motors ,but i see that when i hold the throttle down the motors still spin at a low speed can you explain me this problem?thank you very much
hello;i have this error when i did make , i don't find this file ComputeAggregateTypeSignature.hpp:c:/px4/Firmware/uavcan/libuavcan/include/uavcan/protocol/data_type_info_provider.hpp:10:61: fatal error:…
"hello;
i have a problem in the toolchain installation, in the step of the console build i find this error: make 1 :Entering directory make 1 leaving directory error2
this error it's displayed in this file attached.
how i can resolve this error…"
i have a problem in the toolchain installation, in the step of the console build i find this error: make 1 :Entering directory make 1 leaving directory error2
this error it's displayed in this file attached.
how i can resolve this error…"
"it's must usually do the arming of motors to spin the motors or i can spin automatically the motors after finishing the arming ?"
hello the motors spin only after doing the arming of motors , but when i unplug the battery i can't spin the motors againwhat's the problemthank you very much
helloi work indoor so i have the the led of PIXHAWK is flashing blue but the led of the module GPS 3DR is red do you think that there is a problem ?thank you very much
