"Is it ZIII XL? Zephyr`s III bigger brother. Exactly the same. Just bigger."

"Try Radio calibration. I recommend you to spend some time reading the instructions. It will answer all your questions."

"Doesn't matter. First Change the direction of the prop. Power it up give some throttle. If its pushing backwards then swap any of two wires of your motor going to your ESC. If it is pushing forward then no need to change the motor wires. Just Fly :)"

"Hi. I am 100 % sure your prop is reversed. Change its direction and see the difference. Make sure the numbers on the prop are facing towards the nose of the plane. And you also need to swap couple of motor wires to reverse the rotation.
Well this is…"

"Ok. I am using a plane version so i have to use the 2.4.0.1? Or i can still use 2.4.0.0?"

"Guys, can i use my old 2.4 customized chartset with the latest firmware?"

"Thanks. It worked."

"I will try that. But at the same time i would like to share my personalize Osd version https://www.youtube.com/watch?v=rds9ghfxME4"

"I know how to compile it. But downloading is kind of tricky. I am not getting any response after this command.
Then after force stopping it says unable to connect to repository at URL ......"

"After downloading and installing SlikSvn what should i do now? :(
I went to cmd and type that command svn checkout http://code.google.com/p/minimosd-extra/source/browse/#svn%2Ftrunk%...
But it doesn't do anything. Look like its stuck."

"Guys i am new to this thread. How i can download the Source from http://code.google.com/p/minimosd-extra/source/browse/#svn%2Ftrunk%..."

"No its not normal. It should not be more than 0.8-1 amp if you are running 600 mw transmitter through your flight packs. You may need to calibrate your current sensor. You need a watt meter for it.
Well i don't have a watt meter but what i usually…"

"Are you using PPM sum? and what radio are you using?"

"No i think i haven't make my point clear. I am using the channel 7 for flight modes so its working fine. My RSSI from receiver to APM is from ch4-ch8. I have said that i am only using total 7 PPM channels from my radio so that the ppm channel 8 (…"

"Sir i totally understand your advise and followed it completely. But my case is a little strange. I am taking PPM sum from channel 1 as i am using 4 ch EZUHF receiver so i have 3 channels left. I used channel 4 for link as i am not using rudder on…"

"Ok that means i can attach the cable from channel 4 from my 4 ch lite receiver (mapped to link) and put it on channel 8 input of apm.
Then what will happen to the flight mode channel? It is also 8 by default in apm right?"