Members

All Members (93623)

Antilatency CoPilot: High precision auto landing for drones

Hi, we’re Antilatency, and we’ve developed a tracking system. We started working on it in 2016, released it in 2019, and we’re proud to say that now over 1500 VR and Virtual Production customers in 60+ countries have their projects powered by Antilatency tracking. Recently we started working on an autonomous drone landing system, and we’re excited to show you our MVP. We call it CoPilot. We used our positional tracker with Raspberry Pi connected to PX4 autopilot (pixhawk) via MAVLink protocol.…

Read more…
0 Replies

Brushless Motor

Hey! Friends, I found several charts about brushless motors (Brushless Motor Chart), which explain the relationship between motor size, voltage, and speed very well. Honestly, this knowledge is very helpful for beginners. Saving these charts will save you time.

Read more…
0 Replies

Do you have any suggestion for an Intro computer design project?

Hello,I'm trying to learn more about the depths of computer design, I'm talking about CPU design. Down to the very very low level of Computer Organization.I took a few EE (I did a CS degree so...) classes in college, but it was mostly Introduction and Logic gates (which I do understand). However it never went much further than that. Im not looking to build a Computer from scratch or anything, but what would be the most SIMPLE starting point for someone interested in this. I was thinking maybe a…

Read more…
0 Replies

Suggestions on an appropriate flight control stack for 5" camera drone

I am building my first 5" camera drone. I need suggestions on a suitable Flight Control Stack and quad ESC with at least 45 amps. I don't want a bare bones controller but one that has lots of room to grow with new features. I will be using BetaFlight for the firmware.Can someone recommend 30x30 stack or even a 20x20 stack? Prefer a 30x30 because it is easier to solder but if there is a good reason for 20x20 that will work too.I would like to keep it around $100-$150 if that is possible.This is…

Read more…
0 Replies