the frame is done and the motors are installed also the new props are on for these photos all i am waiting on is the arrival of the apm 2.0
You need to be a member of diydrones to add comments!
the frame is done and the motors are installed also the new props are on for these photos all i am waiting on is the arrival of the apm 2.0
You need to be a member of diydrones to add comments!
Comments
@Todd, hello my friend. thanks for the complements i just ordered my APM 2.0 so about 12 weeks out at this point, i plan to use sonar and an optical flow sensor on it as well to get the best performance i can. i do plan to do a write up on it i am taking lots of photos of the build. did you see the props i found for it i am hoping that my motors will spin them if not i have another motor that may work better anyway i will keep you up to date as it develops
thanks again Dan
I saw your build the other day, freakin amazing Daniel! When will it be ready to test? Hope you do a write up on it.
the props are 16 in in dia. and can be found here multicopter props they have forward and reverse directions they cost 43$ each but are very well made and balanced from the factory