Futaba T14 Mz Mode configuration for all 6 modes

Here a quick guide how to set up your Futaba T14

I use 2 switches

1st switch “SE” – 2 position switch

2nd switch “SB” 3 position switch

Switch “SE” – Master Switch “SB” - Slave

How it works:

Switch “SE” “UP” position switch “SB” select modes 1,3,5

Switch “SE” “Down” position switch “SB” select modes 2,4,6

Step 1 .To get the right min/max PWM output we first need to set the Endpoint of channel 5, in my case name of channel 5 is “ Aux 1”

Linkage menu > EndPoint (ATV) > ch5 Aux 1 Travel value 65% and 72% as showed photo

Step 2. Model menu >Prog. Mixes > select 1st mixing

Set Master “SW-E” and Slave Aux 1 , Value “Offset by X and Y +25%

To get "Logic " window:

Click second "On" ( after green "on" )

What's all, enjoy..

Comments

Eduardo Carrillo March 4, 2018 at 6:25pm

HOLA AMIGOS, ALGUIEN ME PUEDEN AYUDAR CON QUE RECEPTOR TRABAJA EL T14MZAP PARA CONECTAR PIXHAWK
Frederico Fernandes March 9, 2015 at 3:47pm

Hi.

I recently update the software of my T14MZP to Editor Ver. 1.7.0 and Encoder Ver. 1.47. I think this is the last update available. After the update, I saw that, on power up, there is no options to turn off the RF output to, for example, perform a range check. Exploring this issue. I realize the following procedure to overcame this issue:

- With the transmitter off, put the throttle stick all the way up

- Turn on the transmitter

- After the screen lights up, we have a Warnig to confirm to continue

- Put the throttle stick in lower position and... that's it.

Frederico Fernandes,
Tamer Demircioglu November 21, 2013 at 9:26am

happy to solve your problem ;)
ESC32 November 20, 2013 at 7:59pm

Rate A & Rate B changed to 25%, it works!
ESC32 November 19, 2013 at 5:48pm

Thank you Tamer advise. Would you mean Rate A & Rate B?
Tamer Demircioglu November 19, 2013 at 9:19am

at futaba 14-18 MZ owners if it does not work try to increase both rates to %25 instead of offset ! this could be solve your problem.
Eagle Wong October 14, 2012 at 7:53am

i m using 18mz, i m following 14mz instruction. Unfortunately, the SE switch didnt function and SB switch work normally. Any experience on 18mz mode selection config?
Steven Thompson January 27, 2012 at 11:50am

Notice that my T14 had some different screens then Alex's so I updated the firmware.

Here are the instructions for anyone that is hunting for them.

http://www.futaba-rc.com/faq/faq-14mz-q864.html

I found the software updates easily enough off the main http://www.futaba-rc.com but the instructions were not directly linked from the same page.

Also, after the update, the radio no longer asks to be turned on or off at power up?

I will try and program the two switches with Alex's instructions next.
3D Robotics

Chris Anderson January 25, 2012 at 1:41pm

Thanks, Alex. I've posted that in the manual here.