Mapping solution with low cost fixed wing airframe

Hello,

I offer for sale a low cost solution to do mapping with different camera that can be easily placed in the airframe thanks to the battery front cover. The other advantages are easy connections between the airframe and the wings or the elevator for quick and safe assembly / disassembly.
I hope that my solution will catch your attention and allow you to make flights easily.

For information and buy      http://www.uav40.com  

Views: 2262

Comment by Stanley Anak Suab on January 19, 2017 at 8:10pm

Hi Eric, 

I like your canopy design. Genius! :-D

Comment by Eric on January 20, 2017 at 5:41am

Hi Stanley,

thank you.


100KM
Comment by Hein du Plessis on January 20, 2017 at 6:34am

Best Skywalker industrialisation I've seen yet! Well done, you've taken away almost all the pain and danger of setting deploying a Skywalker.


100KM
Comment by Hein du Plessis on January 20, 2017 at 6:34am

Best Skywalker industrialisation I've seen yet! Well done, you've taken away almost all the pain and danger of setting deploying a Skywalker.

Comment by Eric on January 20, 2017 at 8:10am

Hello Hein du Plessis

Thank you for your opinion, I think the skywalker offers many possiblites at reduced cost for aerial photography, but I work on other use that I will soon to commercialize, stay tuned for news.

Bye and good flight

Comment by Tobias on January 21, 2017 at 1:43am
You could give some notice that this thing is based on Ardupilot/Arduplane. And that it is based on open hard- and software.
Comment by Pascal P. on January 21, 2017 at 3:26am

Eric, nice and clean setup. But what about the camera location ? Hole in bottom ? protection ?

Comment by Pascal P. on January 21, 2017 at 3:28am

Also you should target more flight time with bigger lipo or best : li-ion pack

Comment by Eric on January 21, 2017 at 11:14am

hello Tobias,

Actually I forgot to specify that the software used are opensource, thank you remind me I will make changes on the website soon.

Comment by Eric on January 21, 2017 at 11:24am

Hello Pascal,

Thank you for your positive opinion on my configuration, concerning the location of the camera or other sensor, this is done at the request of the customer or made by himself. Regarding autonomy for most missions 40 mins are sufficient, but this can be increased easily by replacing the battery by a bigger one.
The choice of the battery is made according to the load to be carried and the distance to be covered by the customer to make his own choice according to his needs.

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service