Good afternoon everyone. I recently finished my 3D-Printed X4 frame, and have installed all required (Pixhawk) electronics. Everything is working great, and I have done a successful test flight;…Continue
"That is a counterfeit ublox part. That is a Chinese knock off. You have been cheated. The way to tell is quite simple.
Each ublox chip has a unique serial number. Every ONE! The smart tag on the ublox chip that you have…"
"I've got the exact same issue-- it's not a bad GPS-- I took my m8n and connected it to an APM and it worked fine. If I rearrange the wires going into the Pixhack, I get "no gps" in Mission Planner - if I get the wires connected…"
"Justin,I'm unsure reading through the thread if you have decided on a new multi-rotor yet. Here's my take;I'm a UAV instructor, and the company I'm currently working for uses Phantoms for students on the flight line.. I,…"
"Rob, I used the Pixhawk Controller as a way to access the GPS in u-Center. According to u-Blox, this isn't the best way to do so, but it should still provide data.I got off the phone earlier today, for a second time, with u-Blox support. It…"
"Looking at your pictures the wires appear to be correct. The yellow RX from gps is going to TX on pixhawk and TX from GPS is going to RX on Pixhawk. The other thing you might do with an ohm meter is check that the wires aren't broken somewhere.…"
"Nice work, i love it. Prop wash is definitely one of the factors. That is why i always put a bit of foam on the baro. This really helps to stabilize the baro readout. Google pixhawk baro foam for more info. "
"You know, I've been looking it up a bit. It could be a few variables such as prop wash. I also have to open up the board and check to ensure nothing is blocking it. I'm just about finished with my scratch built carbon fiber frame. Itching…"