Comments

• 

  barbeyrac November 17, 2011 at 8:38am

  switch loiter mode is only the way for the quad stay on the gps position, or before we must define loiter point with a another switch like channel 7 ?
• 

  Allen Bishop November 17, 2011 at 7:19am

  Do we have a release date for .50?  Days, Weeks ???

  Thanks

  Allen
• 

  Todd Hill November 17, 2011 at 7:16am

  Pull from Git.  .50 is working pretty darn well on me quad and Y6.
• Tomas Soedergren November 17, 2011 at 7:01am

  Yes Dave, I know. I was just thinking that if .50 comes with major changes I might have to start tweaking parameters once again when transitioning from .49. Not a problem but not optimal ;)
• 

  Dave November 17, 2011 at 5:16am

  You can always just update your firmware (and backup any tunings you have made) when it comes out if you carry on with 49 now.
• Tomas Soedergren November 17, 2011 at 5:00am

  Development team: - When might we expect 2.0.50 release?

  (if it´s just around the corner I might put my setting up of a new quad on hold until new FW arrives)
• ahmed hakeem November 13, 2011 at 10:51pm

  Thank You .. i will post there
• Moderator

  Michael Pursifull November 13, 2011 at 10:49pm

  @ahmed - please make a post in the forums, where we can reply to your questions better. In the user group, we cannot have threaded replies. Please provide photos, video, and details about your frame and motors and props (custom? ArduCopter2/jDrones? 3DR frame? Other?) What version of Mission Planner and what version of ArduCopter?

   

  Also, please read the manual about troubleshooting, and learn about auto trim, sensor aliasing and vibration, center of gravity, and ground effect.

   
• ahmed hakeem November 13, 2011 at 10:43pm

  Finally i connected the quadcopter

  and everything its ok the Tuning . all motors run same time and all Speed Control Deeps same time

  im trying to fly and trying hover the quadcoper like crazily when i try to take off and fail down its like when the gyro set in more sensevety 

  i connect the quadcopter with Mission Planer (APM PLANNER)

  Then go to (Configuration)  -----> AC2

  what must be the numbers there  in Stabilize Roll .. Pitch .. Yaw .. loiter .. ??

  when i connected i git this numbers .....Roll and Pitch (p) 4.600 (l) 0.001 (imax) 1.500

  Yaw (p) 7.000 (i) 0.010 (imax) 8.0 .... Loiter (p) 0.300 (i) 0.000 (imax) 12.0

   

  also Rate Roll and Rate Pitch (p) 0.145 (i) 0.000 (imax) 15.0

  Rate Yaw (p) 0.130 (i) 0.000 (imax) 50.0 .... Rate WP (p) 3.000 (i) 0.250 (imax) 20.0

   

  That is all when i connect..Did i must Change the Numbers ???
• 3D Robotics

  Chris Anderson November 12, 2011 at 10:18pm

  Adil: Set one of your toggle switch modes to Loiter. Wait for GPS lock, then fly and switch into Loiter at the position you want to hold.