Comments

• 

  Bradley J Carr April 10, 2012 at 1:09pm

  Does my plan look like a simple takeoff and couple points then rtl and land.
• 

  Rui Manuel Cravo Marques April 10, 2012 at 12:56pm

  Hello Bradley. Having done some auto flights with my quad, I can tell you that your home location will be set to the point where you arm the copter and take off. It's very important you have a solid gps lock before doing so.
• 

  Bradley J Carr April 10, 2012 at 12:49pm

  Here is my mission.  If you see something wrong please tell me.
• 

  Bradley J Carr April 10, 2012 at 12:44pm

  Getting ready for my first Auto FLight with my 3DR quad.  One question before I go.  I have mission planner up and running and going to make a flight plan before I head out.  When I get out there will the home alt and coordinates lock, Since I can't set those unless I am out there with the computer.
• 

  Wessie April 10, 2012 at 12:03am

  @Andre - I used to put the Yaw D value to 6 before, that gave me a crisper rudder command. Try it, let me know if it has the desired effect.

  Wessie
• 

  Andre Kotze April 7, 2012 at 6:34am

  Which PID value would I adjust to make my quad's rudder input more sensitive?
• 

  Jason April 3, 2012 at 3:28pm

  Ian, I have/had some trouble like this on my Jdrones Hexa... under the "Motors" command, my motors started firing out of order, instead of starting with motor 1 like it should on the hexa in + config... it started with #4 and continued around the loop. I couldn't get help on it yet, but logically, I figured if I move all my ESC jumpers 1 slot ccw, it should line my motors up properly...  it didn't, they moved one more slot further away on cw.... I am going to try and go the other direction now and see what happens tonight.
• Mark Slater April 3, 2012 at 10:57am

  @Ian,  I had some trouble with Oct configuration. The correct connections are here 

  http://code.google.com/p/arducopter/wiki/AC2_Props_2
• Developer

  Adam Rivera April 3, 2012 at 6:59am

  Ian: See this link: http://code.google.com/p/arducopter/wiki/APM2_Motor_order It is already in the wiki. I am assuming you have an APM2.
• Ian forbes April 2, 2012 at 10:48pm

  Need some x 8 help... Do I use Ardu coptor V2.5.3 octa X firmware?  I have all my motors setup as per wiki X8 counter rotating diagram, but when I run the motors test, it does not conform to the video in the motors test. 

   Motors are absolutely wired correctly, I disconnected and listened for esc beeps to test, and they are correct, what am I doing wrong?  Instead of 1-6 4-7 3-8 2-5 like the video, mine is firing 1-3-8-4-2-6-7-5, I can't find any info on proper firmware setup for this config, any help would be appreciated...