Comments

• Developer

  Randy September 26, 2012 at 3:14am

  @Zachary re frying board through errors in the arducopter program,

      I don't think that's possible.  For things like an ESC where you've got large voltages that are being controlled by the firmware it's possible but as for the arducopter software, it's just running a program that changes signal out to ESCs, xbees, etc so I can't imagine how that could happen.
• Zachary Koh September 26, 2012 at 2:17am

  Is it possible to fry your apm board through errors in the arducopter program?
• 

  Altaf September 25, 2012 at 9:01am

  How to add a flight mode of my own. .. ??
• Developer

  Randy September 19, 2012 at 8:32pm

  @Lucas re obstacle avoidance,

      Somebody asked that same question on the sonar wiki earlier today, i guess it's a popular thing that people want.  We don't support that at the moment and no specific plans to add it although it wouldn't be too difficult.  People would have to buy at least 4 more sonars though..$120-ish..not terrible i guess.
• Lucas Tan September 19, 2012 at 8:12pm

  What are the features that can be realised for an Arducopter? 
  Are there something like obstacles avoidance?
• Developer

  Randy September 18, 2012 at 9:14pm

  @Bradley re what is the pwm coming out of RX.  If you have your APM connected to the mission planner, go to the configuration screen, radio configuration screen and below or beside each of the green bars you will see the raw pwm value.
• 

  Bradley J Carr September 17, 2012 at 9:53am

  Could somebody tell me what the PWM is coming out of a RX.  I don't have my scope anymore so I really don't have a way of telling.  I needed to see what the range is coming out of my futaba radio..
• 

  Daniel Chapelat September 14, 2012 at 5:59am

  Bonjour,

  une petite question: avec Mission Planner 1.2.11 comment avoir la fonction "Prefetch" ? le bouton a disparu!!

   
• Zachary Koh September 11, 2012 at 8:28pm

  Hmm, we've just received another bigger, heavier, more powerful quad. It was passed down to us from a couple of people who have flown it fine before.

  After re-assembling it, we tested it's flight. During rolling, the motors on the relevant side are supposed to power up to allow it to roll, however one does not do this. This is the same when rolling in either direction. Does anyone know a fix for this?

  Thanks. X)
• Developer

  Randy September 10, 2012 at 7:51pm

  @Zachary re getting help understanding the arducopter code,

       You could start a discussion (which allows threads in the reply) here or in the "Learning to program the ardupilot mega" group.  Good luck