Comments

• Dennis Fuente January 13, 2014 at 1:49pm

  Hi Guy's 

  So after checking my APM voltage regulator out put per the link it had 4.4 v so i ordered the new parts from digi key the board is the 2.5.2 they came i installed the new reg checked the out put of the new reg it measured 4.8 v so what gives ?

  Dennis 
• 

  Essam January 9, 2014 at 6:28pm

  Hi guys,

  Any advice on what gimbal model will allow me to use two cameras simultaneously? I am not sure if such a gimbal exists? Additionally, would it be possible to remotely trigger two cameras at the same time? Thanks
• David Houghton January 9, 2014 at 4:22am

  just found a video as well

  https://plus.google.com/u/0/101647272150347478891/posts/WCXLZ2UFPBU...
• David Houghton January 9, 2014 at 4:18am

  these look interesting may order 1

  http://www.ebay.co.uk/itm/Arducopter-LED-Status-Indicator-case-only...
• Dennis Fuente January 8, 2014 at 1:37pm

  the voltage is 4.3 v and my flight data page was not going crazy as most have described only the bad gyro health so wait and see i guess.

  Dennis 
• 

  Bo Wingo January 8, 2014 at 1:28pm

  Good deal.  Just out of curiosity, what voltage did you measure?
• Dennis Fuente January 8, 2014 at 1:16pm

  I have checked the voltage at the regulator and it is above 3.3 v so i have ordered a replacement for it my hope is that nothing else has gone down.

  Thanks for the help

  Dennis
• 

  Bo Wingo January 8, 2014 at 11:25am

  @Dennis,

  This regulator is being used to take the 5V board input and regulate it down to 3.3V.  When a regulator fails, it could fail multiple ways, no output (Hi-Z), output grounded, or output shorted to input, for example.  This one in particular seems to favor failing with the output (normally 3.3V) shorted to the input (5V).  You will need to perform the check documented in the video on the page that I linked to confirm if this is indeed the issue that you are observing.  It's a pretty simple test if you have a basic multimeter.  If that's the issue, replacing the regulator should get you back up and running.
• Dennis Fuente January 8, 2014 at 10:24am

  Ok so help me wrap my head around this the regulator blows but it dose not blow open as i would expect it leaks a higher voltage i think the chip quality is the issue.

    So after the regulator is replaced everything works normally ?

  Dennnis  
• 

  Steve Lewis January 7, 2014 at 1:43pm

  Thank you Bo Wingo! This is exactly what I need.